9.SELECTED PRESET POINT: The current preset point being defined/edited.
10.STOP TIME: How long the camera will pause at each preset point when using
CRUISE MODE.
11.GOTO: Moves the camera to the selected preset point.
12.DEFINE: Saves the current position of the camera as a preset point.
13.ERASE: Deletes the selected preset point.
14.SAVE: Saves changes.
15.EXIT: Leaves the PTZ SETUP menu.
Setting up Cruise Mode
To setup CRUISE MODE, you’ll need to define “POINTS”
for each channel with a PTZ camera you want to
“cruise”. A POINT is one place that the camera needs to
move to on its loop.
•Move the camera to the desired position using the arrows.
• Hit the | button. |
•The point will be saved. Its name will be one digit higher than the previous point.
•For easy cruise setup, define your points in the same order as you want the camera to move through them.
The | button will take the camera back to a pre- | |||
defined point. The | button will remove all your de- | |||
fined | points. |
|
|
|
When you’ve set your points, select | then | . | ||
•To start cruise mode, select START CRUISE from the
•To stop cruise mode, select STOP CRUISE from the same menu.
Remember: Before Cruise Mode will work, you’ll need to have enabled the PTZ Configuration menu. See page 46.
61