Furuno IF-NMEASC manual Adjustments, LEDs and Equipment Status, LED state and equipment status

3.ADJUSTMENTS

3.1LEDs and Equipment Status

The six LEDs above the heading indication light, flash or go off according to equipment status.

GPS OUTPUT PROCESSING

Status LEDs
for SC-30	SENSOR1

CR33: Status LED for IF-NMEASC

SENSOR2

Heading Pitch Roll

Sentence Bps Output

Interval

Sentence Bps Output

Interval

Menu/ Enter

Cancel

LED state and equipment status

-

+

LED	LED state and equipment status
GPS	ON: Both GPS antennas in the SC-30 are receiving from five or more satel-
	lites.
	OFF: One of the GPS antennas is receiving from 3 or fewer satellites.
OUTPUT	ON: All data is output from the SC-30 normally.
	Flashing: Motion (heading, roll, pitch) is output (heave is fixed at 0, position
	and speed are normal) by dead reckoning.
	OFF: Heading output is stopped.
PROCESSING	ON: GPS processor is functioning properly.
	Flashing: Initializing for GPS.
	OFF: Not enough satellites received.
SENSOR1	ON: Rate gyro normal on all three axes.
	OFF: Rate gyro error.
SENSOR2	ON: Acceleration sensor normal on all three axes.
	OFF: Acceleration sensor error.
CR33	Flashing: Valid NMEA 2000 data is input.
	ON: No valid NMEA 2000 data is input.
	OFF: CPU error, or no power.

4