Compex Systems 802.11N manual Ping Watchdog, Auto-Reboot

Page 55

Ping Watchdog

Enable Ping Watchdog: Default is disabled. Check on box to enable.

IP Address To Ping: Target IP address do ping test monitor.

Ping Interval: Default is 5 seconds (minimum). This is Ping test duration.

Startup Delay: Default is 60 seconds(minimum). One time delay after device startup.

Failed Count To Reboot: Default is 5. This is the number of ping failure count before device kick in the reboot process.

Auto-Reboot

Auto-Reboot Mode: Default is disabled. Select By Hour or By Time check.

This mode lets you preset a timer to automatically force a reboot. Timer can in fixed number of hours or at a specified time of day.

By Hour: Enter the number of hours device need to run before kick start reboot process.

By Time: Enter the specific time of day in hh:mm (24-hour format) to kick start reboots process.

Image 55

Contents Page Trademark Information FCC Notice Declaration of Conformity Table of Contents Status System TabIntroduction Overview the ProductVirtual AP Multiple Ssid Highly Secured Wireless NetworkUConfig Utility Point-to-Point & Point-to-MultiPoint SupportAccess Point WDS Mode Station Mode Point-to-Point Station WDS ModeRouter Mode Repeater WDS Mode Device Panel Views and Descriptions Features Status and IndicationsAntenna Alignment Install the HardwareAntenna Alignment Installation Direction Mount the Unit on a Pole Setup RequirementsPrepare Unit to mount to a pole Page For Windows 95/98/98SE/ME/NT Configure the IP AddressStep Select the Use the following IP address radio button For Windows XP/2000Click on the OK button to close all windows Access with uConfig Access the Web InterfaceStep It then opens the device home page. The Status Access with a Web Browser Step Navigation How to save changesMain Menu Bar Basic Network Tab LAN SetupNetwork Modes Bridging and Routing Primary DNS IP optional Enable the radio Basic Wireless TabBasic Wireless Settings Wireless Mode Country Code Access Point Parameters SettingsWireless Profile Local AP-ESSIDRate Aggressiveness Channel Spectrum WidthChannel Frequency Data RateRemote AP-ESSID Station Parameters SettingsRemote AP Preferred MAC Channel Scan List Wireless Adapter modePreshared Key Wireless SecurityWPA or WPA2 Authentication Cipher TypeAccounting Port Authentication PortPrimary Radius Server IP Secondary Radius Server IPUser Password Station, Station WDS, Repeater WDS mode IdentityUser Name IEEE802.1x Key Rotation IEEE802.1x SettingsIEEE802.1x Key Length WEP Key Authentication TypeKey Type Current KeyVirtual Access Point VAP Long Range Parameters Setup Advance Wireless TabLong Range Parameters Noise Immunity Signal Strength Indicator RssiAdvanced Network Tab NAT Setup Spanning Tree SetupAdding an entry from Known Server Adding an entry from Custom Server Rule Type select By IP or By MAC Bandwidth ControlRouter Info Protocol version select RIPv1 or RIPv2 Firewall Setup Outbound Filtering Setup Page Services Tab Ping Watchdog Auto-RebootWeb Http Security Snmp SetupNTP Setup Engine ID Default isSSH Access Setup Telnet Access SetupSystem Log Setup System Tab Firmware UpgradeRead-Only Username Administrative and Read-only AccountEnable Read-Only Account Host NameDevice Maintenance Configuration ManagementStatus Reporting StatusMain WAN Setting LAN SettingRadio Wlan Local AP Statistics Station Connection Status InfoWlan Connected Status Channel WidthPage Appendix I Network Bridge ModeNetwork Mode Selections Bridge Mode Network SettingsPrimary/Secondary DNS IP Bridge IP AddressDhcp Fallback IP Spanning Tree Protocol Bridge mode Firewall Configuration SettingsAP-Router mode Network Settings Appendix II Wireless with Router ModePage Port Forwarding Settings IP of the host system which sends the packets Page Advanced Wireless Setting Appendix III- Advanced SettingsRate Aggressiveness Acknowledgement Timeout LED Thresholds Configuration Signal Strength LED SettingsSnmp Agent Appendix IV- ServicesSystem Log NTP Client, Web, Telnet, SSH Server