Compex Systems 802.11N manual Step

Page 22

Step 5:

To verify that the IP address has been correctly assigned to your PC, go to the Start menu, select Run, and enter the command: winipcfg.

Select the Ethernet adapter from the drop-down list and click OK.

PC is now setup with proper IP address to communicate with the access point.

Image 22

Contents Page Trademark Information FCC Notice Declaration of Conformity Table of Contents System Tab StatusOverview the Product IntroductionPoint-to-Point & Point-to-MultiPoint Support Highly Secured Wireless NetworkUConfig Utility Virtual AP Multiple SsidAccess Point WDS Mode Station Mode Station WDS Mode Point-to-PointRouter Mode Repeater WDS Mode Features Status and Indications Device Panel Views and DescriptionsInstall the Hardware Antenna AlignmentAntenna Alignment Installation Direction Setup Requirements Mount the Unit on a Pole Prepare Unit to mount to a pole Page Configure the IP Address For Windows 95/98/98SE/ME/NTStep For Windows XP/2000 Select the Use the following IP address radio buttonClick on the OK button to close all windows Access the Web Interface Access with uConfigStep It then opens the device home page. The Status Access with a Web Browser Step Navigation How to save changesMain Menu Bar Basic Network Tab LAN SetupNetwork Modes Bridging and Routing Primary DNS IP optional Enable the radio Basic Wireless TabBasic Wireless Settings Wireless Mode Local AP-ESSID Access Point Parameters SettingsWireless Profile Country CodeData Rate Channel Spectrum WidthChannel Frequency Rate AggressivenessRemote AP-ESSID Station Parameters SettingsRemote AP Preferred MAC Wireless Adapter mode Channel Scan ListCipher Type Wireless SecurityWPA or WPA2 Authentication Preshared KeySecondary Radius Server IP Authentication PortPrimary Radius Server IP Accounting PortUser Password Station, Station WDS, Repeater WDS mode IdentityUser Name IEEE802.1x Key Rotation IEEE802.1x SettingsIEEE802.1x Key Length Current Key Authentication TypeKey Type WEP KeyVirtual Access Point VAP Long Range Parameters Setup Advance Wireless TabLong Range Parameters Signal Strength Indicator Rssi Noise ImmunityAdvanced Network Tab NAT Setup Spanning Tree SetupAdding an entry from Known Server Adding an entry from Custom Server Rule Type select By IP or By MAC Bandwidth ControlRouter Info Protocol version select RIPv1 or RIPv2 Firewall Setup Outbound Filtering Setup Page Services Tab Auto-Reboot Ping WatchdogEngine ID Default is Snmp SetupNTP Setup Web Http SecuritySSH Access Setup Telnet Access SetupSystem Log Setup Firmware Upgrade System TabHost Name Administrative and Read-only AccountEnable Read-Only Account Read-Only UsernameConfiguration Management Device MaintenanceStatus Reporting StatusMain WAN Setting LAN SettingRadio Channel Width Station Connection Status InfoWlan Connected Status Wlan Local AP StatisticsPage Bridge Mode Network Settings Bridge ModeNetwork Mode Selections Appendix I NetworkPrimary/Secondary DNS IP Bridge IP AddressDhcp Fallback IP Bridge mode Firewall Configuration Settings Spanning Tree ProtocolAppendix II Wireless with Router Mode AP-Router mode Network SettingsPage Port Forwarding Settings IP of the host system which sends the packets Page Advanced Wireless Setting Appendix III- Advanced SettingsRate Aggressiveness Acknowledgement Timeout Signal Strength LED Settings LED Thresholds ConfigurationAppendix IV- Services Snmp AgentNTP Client, Web, Telnet, SSH Server System Log