Datalogic Scanning DS4300 manual Red, indicates the reader is connected to the power supply

Page 14

DATALOGIC

DS4300

Electrical connection is provided through a cable on the side of the reader; this cable is terminated with a 25-pin connector (25-pin connector models, see paragraph 1.3, Figure A, 1 ) or by a junction box (junction box models, see paragraph 1.3, Figure B, 1 ).

The laser beam output window is on the right hand side of the scanner (Figure A/B, 10 ). A green LED on the same side indicates the laser is active (Figure A/B, 9 ).

A security system allows the laser to activate only once the motor has reached the correct rotational speed; consequently the laser beam is generated after a slight delay from the power on of the scanner.

The four LEDs on the left hand side of the scanner indicate the following:

READY

(red), indicates the reader is connected to the power supply

 

and the startup was successful. If the startup is not

 

successful, this LED blinks. (Figure A/B, 3 ).

GOOD READ

(red), is used to signal successful barcode decoding. It is

 

also used in Test mode to signal the decoding percentage

 

(for details refer to the section "Test Mode" in the WinHost

 

Help On Line). (Figure A/B, 4 ).

EXT TRIG

(yellow), indicates external trigger activity (for details refer to

 

par.2.4.4. (Figure A/B, 5 ).

TX DATA

(green), indicates data transmission on the main serial

 

output line. (Figure A/B, 6 ).

The screw holes on the body of the reader are for mechanical fixture (Figure A/B, 2 ); the screw holes shown in Figure A/B, 11 are to attach accessories such as the optional 90° mirror.

General Features - 1.3

Image 14
Contents Page Installation Manual DS4300Datalogic S.p.A DS4300-XXXX, Laser Scanner and all its modelsContents Maintenance Guide to Installation DS4300 General ViewFigure B Standard Regulations Safety PrecautionsLaser Safety Laser diode class label Power Supply Standard Application Program General FeaturesIntroduction ProgrammabilityDescription Red, indicates the reader is connected to the power supply DS4300 AccessoriesAvailable Models Installation Package ContentsMechanical Installation Overall dimensionsJunction BOX Installation Junction Box MountingJunction box mounting Junction Box Electrical Connections System cable connections to the junction boxBOX pinout for DS4300 Pin Name Pin RS232 RS485 MA CL Full-duplexScanner cable connections to the junction box Pin D-sub connector pinout Name Function Electrical Connections for 25-PIN ModelsPower Supply DS4300RS232 Main Serial InterfaceRS232 Pin Name Function13 RS232 main interface connections RS485 Full-Duplex 15 RS485 full-duplex connectionsRS485 Half-Duplex MultiplexerChassis MA Current Loop INT-24 Accessory Only ClinAuxiliary RS232 Interface InputsEXT TRIG+ 22 Input PNP command using external power Outputs 24 Open collector output connectionPositioning 25 Pitch angleTypical Layouts Point-to-PointPass Through DS4300 Host Main serial interface3 RS232 Master/Slave 30 RS232 Master/Slave layout4 RS485 Master/Slave HostMultiplexer 32 Multiplexer layoutThis page is intentionally left blank Installation Reading Features Advanced Code ReconstructionTilt Angle for Advanced Code Reconstruction Tilt angleSN = LH/LS * SS Decoding Capacity in Linear ModeStep Ladder Mode Picket Fence Mode SN = FW-LW/LS * SSPerformance Reading Diagrams DS4300-100X Code Resolution StandardDS4300-100X Code Resolution High Code Resolution HighThis page is intentionally left blank Reading Features Maintenance CleaningThis page is intentionally left blank Maintenance Technical Features Reading Features NoteSoftware Features