Field Controls 10 manual Pin Assignments

Page 28

Pin Assignments

Hardware Platform 10 Installation Guide

Pin Assignments

RS-232 and RS-485 Serial Ports

	RS-232	RS-232 full	RS-485
Pin	Port 1	Port 2/3 (Option only)	Port 2 (Option only)
	Port 1	Port 2/3 (Option only)	Port 2 (Option only)
1	-	DCD	DATA– (B) inverting

2	RxD	RxD	DATA+ (A) non-inverting

3	TxD	TxD	-

4	-	DTR	-

5	GND	GND	GND

6	-	DSR	-

7	-	RTS	-

8	-	CTS	-

9	-	RI	-

Power Connector

-+

Pin diameter: 2.1mm

Outer diameter: 5.5mm

Pin	Signal Name
inner	+7-18 V DC

outer	GND

28

Image 28

Contents FChwp10 Installation Guide Hardware PlatformPage Installation Warning Safety InformationQualified Personnel Warning Disclaimer Restricted Access Area WarningSoftware License Terms End User License Agreement Power Supply Disconnection Warning Device handlingTable of Contents Ports on your controller Pin Assignments Technical SpecificationsPhysical Dimensions About this manualAbout this manual Organisation of the documentationInstallation System requirementsGetting familiar FrontBack Bottom Physical installation Hardware installationConnecting power Hardware Platform 10 Installation Guide Power Over Ethernet Connecting to the network When you co-locate the controller, you can connect to it through aHardware Platform 10 Installation Guide IP configuration Addressing basicsAssigning an IP address on a FieldCommander Configure IP address with browserUser name admin Password admin currently installed firmware versionname of the user currently logged in currently admin Note that both fields are case sensitiveDynamic Host Configuration Protocol BootpBootstrap Protocol Address Resolution ProtocolForce new IP address using ARP+PING Assigning an IP address on an ELS controller Assigning an IP address on an EWS controller The ping test Testing the Ethernet connectionThe browser test Serial interface RS-232The RS-232c standard The connectionsRS-485 option only The RS-485 standardA Backbone with stubs workable B Daisy chain best C Star network avoid D Mixed, backbone & star avoidThe RS-485 pin-out Ports on your controller Pin Assignments POE GND power return SignalPin Assignments Ethernet ColorHardware Platform 10 Installation Guide VGA VGARedVGAGreen VGABlueTechnical Specifications type C 4GB GB Flash drive 256MB reserved for systemHardware Platform 10 Installation Guide RS-485 Interface option only Network InterfaceUSB Interface option only Video Interface model C onlyPhysical Dimensions All sizes in millimetersNotice to the user RegulatoryCopyrights TrademarksDeclaration of Confority FieldCommander is a product of CER International bv Postbus The latest documentation is availableNL 4700 AG Roosendaal The Netherlands TEL +31 0165 FAX +31 0165 Part no. FCHWP10IG, revision