Field Controls 10 manual Trademarks, Copyrights, Declaration of Confority

Page 35
Declaration of Confority

Notice to the user

Declaration of Confority

Declaration of Conformity

according to ISO Guide 22 and EN 45014

Manufacturer's name:

CER International bv

Manufacturer's address:

Postbus 258

 

4700 AG Roosendaal

 

The Netherlands

declares that the product:

 

Product Name:

FieldCommander

Model Number:

ELS1700/ELS1722/EWS1700/EWS1722/

 

FC2700/FC3700/FC3733/FC3724

Product Options:

all

conforms to the following Product Specifications:

EMC Directive:

89/336/EEC for CE Marking

EN 55022: 1998 (Class A)

EN 61000-3-2: 2000

EN 61000-3-3: 1995

EN 55024: 1998 (IEC 61000-4-2:1995, IEC 61000-4-3:1995,

IEC 61000-4-4:1995, IEC 61000-4-5:1995, IEC 61000-4-6:1996,

IEC 61000-4-8:1993, IEC 61000-4-11:1994)

Supplemental Information: The product herewith complies with the requirements of the EMC Directive 89/336/EEC and carries the TrademarksCopyrights-marking accordingly.

A. van den Broek

General Manager

Trademarks

CER and FieldCommander are registered trademarks of CER International bv.

All other product names and services identified throughout this book are trademarks or registered trademarks of their respective companies. They are used throughout this manual in editorial fashion only and for the benefit of such companies. No such uses, or the use of any trade name, is intended to convey endorsement or other affiliation with this manual.

Copyrights

Copyright © 2008 CER International bv. All rights reserved.

No part of this publication may be reproduced in any form, or stored in a database or retrieval system, or transmitted or distributed in any form by any means, electronic, mechanical photocopying, recording, or otherwise, without the prior written permission of CER International bv, except as permitted by the Copyright Act of 1976 and except that program listings may be entered, stored and executed in a computer system.

THE INFORMATION AND MATERIAL CONTAINED IN THIS MANUAL ARE PROVIDED "AS IS," WITHOUT WARRANTY OF ANY KIND, EXPRESS OR IMPLIED, INCLUDING WITHOUT LIMITATION ANY WARRANTY CONCERNING THE ACCURACY, ADEQUACY, OR COMPLETENESS OF SUCH INFORMATION OR MATERIAL OR THE RESULT TO BE OBTAINED FROM USING SUCH INFORMATION OR MATERIAL, NEITHER CER INTERNATIONAL BV NOR THE AUTHORS SHALL BE RESPONSIBLE FOR ANY CLAIMS ATTRIBUTABLE TO ERRORS, OMISSIONS, OR OTHER INACCURACIES IN THE INFORMATION OR MATERIAL CONTAINED IN THIS MANUAL, AND IN NO EVENT SHALL CER INTERNATIONAL BV OR THE AUTHORS BE LIABLE FOR DIRECT, INDIRECT, SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES ARISING OUT OF THE USE OF SUCH INFORMATION OR MATERIAL.

CER International bv

35

Image 35
Contents Installation Guide Hardware Platform FChwp10Page Qualified Personnel Warning Safety InformationInstallation Warning Software License Terms End User License Agreement Restricted Access Area WarningDisclaimer Device handling Power Supply Disconnection WarningAbout this manual Table of ContentsPorts on your controller Pin Assignments Technical Specifications Physical DimensionsOrganisation of the documentation About this manualFront InstallationSystem requirements Getting familiarBack Bottom Connecting power Hardware installationPhysical installation Hardware Platform 10 Installation Guide Power Over Ethernet When you co-locate the controller, you can connect to it through a Connecting to the networkHardware Platform 10 Installation Guide Addressing basics IP configurationConfigure IP address with browser Assigning an IP address on a FieldCommanderNote that both fields are case sensitive User name admin Password admincurrently installed firmware version name of the user currently logged in currently adminAddress Resolution Protocol Dynamic Host Configuration ProtocolBootp Bootstrap ProtocolForce new IP address using ARP+PING Assigning an IP address on an ELS controller Assigning an IP address on an EWS controller The browser test Testing the Ethernet connectionThe ping test The connections Serial interfaceRS-232 The RS-232c standardThe RS-485 standard RS-485 option onlyC Star network avoid D Mixed, backbone & star avoid A Backbone with stubs workable B Daisy chain bestThe RS-485 pin-out Ports on your controller Pin Assignments Color POE GND power returnSignal Pin Assignments EthernetVGABlue Hardware Platform 10 Installation Guide VGAVGARed VGAGreentype C 4GB GB Flash drive 256MB reserved for system Technical SpecificationsVideo Interface model C only Hardware Platform 10 Installation Guide RS-485 Interface option onlyNetwork Interface USB Interface option onlyAll sizes in millimeters Physical DimensionsRegulatory Notice to the userDeclaration of Confority TrademarksCopyrights Part no. FCHWP10IG, revision FieldCommander is a product of CER International bv PostbusThe latest documentation is available NL 4700 AG Roosendaal The Netherlands TEL +31 0165 FAX +31 0165