Field Controls manual Hardware Platform 10 Installation Guide

Page 14

Manual background

Hardware Platform 10 Installation Guide

To connect the CER controller to your 10/100base-T network, you can use any standard Category 5 (CAT5). A suitable cable is supplied. Attach one side to the RJ-45 socket marked "Ethernet" on the front panel of the unit and the other to your ethernet hub or switch.

Take note of the serial number of your CER controller for future reference during installation. You find the number on the label on the back of the unit.

14

Image 14

Contents FChwp10 Installation Guide Hardware PlatformPage Qualified Personnel Warning Safety InformationInstallation Warning Software License Terms End User License Agreement Restricted Access Area WarningDisclaimer Power Supply Disconnection Warning Device handlingPhysical Dimensions Table of ContentsPorts on your controller Pin Assignments Technical Specifications About this manualAbout this manual Organisation of the documentationGetting familiar InstallationSystem requirements FrontBack Bottom Connecting power Hardware installationPhysical installation Hardware Platform 10 Installation Guide Power Over Ethernet Connecting to the network When you co-locate the controller, you can connect to it through aHardware Platform 10 Installation Guide IP configuration Addressing basicsAssigning an IP address on a FieldCommander Configure IP address with browsername of the user currently logged in currently admin User name admin Password admincurrently installed firmware version Note that both fields are case sensitiveBootstrap Protocol Dynamic Host Configuration ProtocolBootp Address Resolution ProtocolForce new IP address using ARP+PING Assigning an IP address on an ELS controller Assigning an IP address on an EWS controller The browser test Testing the Ethernet connectionThe ping test The RS-232c standard Serial interfaceRS-232 The connectionsRS-485 option only The RS-485 standardA Backbone with stubs workable B Daisy chain best C Star network avoid D Mixed, backbone & star avoidThe RS-485 pin-out Ports on your controller Pin Assignments Pin Assignments Ethernet POE GND power returnSignal ColorVGAGreen Hardware Platform 10 Installation Guide VGAVGARed VGABlueTechnical Specifications type C 4GB GB Flash drive 256MB reserved for systemUSB Interface option only Hardware Platform 10 Installation Guide RS-485 Interface option onlyNetwork Interface Video Interface model C onlyPhysical Dimensions All sizes in millimetersNotice to the user RegulatoryDeclaration of Confority TrademarksCopyrights NL 4700 AG Roosendaal The Netherlands TEL +31 0165 FAX +31 0165 FieldCommander is a product of CER International bv PostbusThe latest documentation is available Part no. FCHWP10IG, revision