Atlantis Land Network Router manual Hardware Installation, Power on, Adsl connection

Page 12

I-Fly Wireless Router ADSL

1.5 Hardware Installation

Power on

Connect the Adapter to power inlet and turn the power switch on, this product will enter a self-test phase. When it is in the self-test phase, the indicators READY LED will be lighted ON for about 8 seconds, and the READY LED will be flashed to indicate that the self-test phase has finished. Finally, the READY LED will be flashed to indicate that router is in normal operation.

ADSL connection

Simply plug one end of the cable into the ADSL port (RJ-11 receptacle) on the rear panel of the Router and insert the other end into splitter .

Connect Router to LAN

Prepare an Ethernet cable to connect Router to Hub or Switch of your LAN. You can connect Router to your PC directly by crossover Ethernet cable.

6

Image 12
Contents Fly Wireless Router Adsl Page Copyright Page Table of Contents Fly Wireless Router Adsl ChapterAn Overview of I-Fly Wireless Router Adsl IntroductionPackage Contents Adsl Modem/Router FeaturesHardware Indicators LED IndicatorsFront Panel IntroductionRear Panel RxD10/100 Link/ActReset SwitchLineRJ11 JackHardware Installation Power onAdsl connection Connect Router to LANUsing Adsl Modem/Router CablingFly Wireless Router Adsl Installing the USB Driver For Windows XPFly Wireless Router Adsl Installation and Configuration Fly Wireless Router Adsl For Windows Fly Wireless Router Adsl For Windows Me Fly Wireless Router Adsl For Windows Fly Wireless Router Adsl Configuring the Network Properties LAN Area Connection Status window, click Properties Click OK to finish the configuration For Windows Click OK to finish the configuration For Windows 95/98/Me Installation and Configuration For Windows NT4.0 Factory Default Settings PasswordLAN and WAN Port Addresses Information from ISP For BT VPI=0, VCI=38 and for KC VPI=1, VCI=50Configuring with Web Browser Fly Wireless Router Adsl Click Show Advanced settings Status HomeStatus Adsl Status Configuration WAN Configuration Status LANSystem Wide Settings Service Category Select UBR or CBR EncapsulationConfiguration LAN Configuration Fly Wireless Router Adsl IP Address Default at Subnet Mask Default atEthernet Mode Setting Configuration NAT ConfigurationFly Wireless Router Adsl Configuration Virtual Server Configuration Configuration- Wireless Installation and Configuration Configuration Bridge Filtering Configuration Configuration DNS Configuration Configuration Save Settings Admin Privilege WAN StatusAdmin Privilege PPP Status Admin Privilege TCP Status Admin Privilege Route Table Admin Privilege Learned Bridge MAC Table Admin Privilege Adsl ConfigurationTrellis Default at Enabled Admin Privilege RIP Configuration Admin Privilege Password Configuration Admin Privilege Miscellaneous ConfigurationDhcp Target IP Igmp Proxy Default at Disabled Admin Privilege Reset to Factory Default Admin Privilege Diagnostic TestChecking LAN Connection Testing Ethernet LAN connection Test PPPoE connection Admin Privilege Code Image Update Admin Privilege Network Code Image UpdateAdmin Privilege System Log Problems Starting Up the Adsl Router Problems with the WAN InterfaceProblems with the LAN Interface Problem Corrective ActionProblems Connecting to a Remote Node or ISP TroubleshootingPower Adapter Physical DimensionWeight Operating TemperatureConfiguration Default VC SettingPPP Service Scenario Bridge RFC RFC 1483 R PPPoA PPPoEPPP password ConfigurationEnd address Lease Time User mode Ethernet modeConfiguration Trellis WiringMisc Configuration WAN side Preferred DNSOn WAN access DMZ Host IPDhcp Relay Igmp proxySupport