PC Configuration
6.The Add Standard TCP/IP Printer Port Wizard opens. Click proceed.
Next> 
to
7.In the Add Port window and Printer Name or IP Address field enter the IP address of the Ericsson W3x (preconfigured 192.168.1.1) and a Port Name, for example IP_192.168.1.1. Click Next> 
.
8.In the Additional Port Information Required window, select the Custom checkbox and click the Settings… 
button.
9.In the Configure Standard TCP/IP Port Monitor window, select Raw as Protocol and type 9100 as Port Number below Raw Settings.
10. Click
OK 
to return to the wizard and click
Next> 
to proceed.
11.In the Completing the Add Standard TCP/IP Printer Port Wizard window, verify your settings and click Finish 
.
12.The Add Printer Wizard – Install Printer Software window is displayed. Select the Manufacturer and Printer and click Next> 
.
13.Enter a name for your printer and click Next> 
.
14.Select Do not share this printer option and click Next> 
.
15.Print a test page to verify that your printer setup is working properly and then click Next> 
to proceed. It could take a minute or two for the test page to be printed.
16. Click
Finish 
in the Add Printer Wizard.
17.Repeat these steps if you have further computers which should have access to the shared printer.
76 |