Motorola ML910TM manual ML910 R1.0 RF Pass-through Upgrade Procedure, Version A

Page 6

9.Burning process and status are displayed.

8.Insert a blank CD/DVD disc into the drive and click the Burn button to create the bootable media.

9.Burning process and status are displayed.

10.Burn process completed successfully message should display. The bootable disc is now ready to begin the upgrade.

11.In order for your notebook to boot from this disc, the Boot Device Priority Sequence must be set in the System BIOS to place the optical drive you intend to use at a higher priority than any other

6	ML910 R1.0 RF Pass-through Upgrade Procedure, Version A

Image 6

Contents What You Will Need ML910 R1.0 RF Pass-through Upgrade Procedure, Version APurpose and Requirements 2 Support RF Pass-through in Retrofitted ML900 Docking StationsML910 R1.0 RF Pass-through Upgrade Procedure, Version A Step-by-Step Procedure ML910 R1.0 RF Pass-through Upgrade Procedure, Version ATo determine the EC BIOS version I. EC BIOS Upgrade Procedure Perform Procedures I, II and III in order5. Click on “Image, Project, Copy” 6. Click on “Disc Image or Saved Project”9. Burning process and status are displayed ML910 R1.0 RF Pass-through Upgrade Procedure, Version A II. ML User Application Upgrade Procedure a. MLSERVICE foldera. Click Start Control Panel Add or Remove Programs 5. Click Yes to install Microsoft Visual C++ 2005 Runtime Libraries 6. Double-click on SETUP.EXE in the MLSERVICE folder7. Click the Next button to continue 8. Accept the default settings and click the Next button 9. Click the Next button to start the installation10. Please wait while MLService is being installed ML910 R1.0 RF Pass-through Upgrade Procedure, Version A 12. Double-click on SETUP.EXE in the MLUA folder 14. Accept the default settings and click the Next button13. Click the Next button to continue 15. Click the Next button to start the installation 16. Please wait while ML User Application is being installed17. Click on the Close button when ML User Application is successfully installed III. ML Administrator Application Upgrade Procedure 2. Uninstall the existing version of the ML Administrator Applicationb. Select ML Administrator Application and click Remove to uninstall 4. Double-click on setup.exe 5. Click the Next button to continue 6. Accept the default settings and click the Next button7. Click the Next button to start the installation 8. Please wait while ML Administrator Application is being installed9. Click on the Close button when ML Administrator Application is successfully installed IV. Enabling the RF Pass-Through Option Using MLAA and MLUA 5. Launch the ML User Application 11. Note that the RF Pass-Through Option will not be applicable under the following conditions