Cyclades PC400 installation manual Software Installation

Page 10
sh install

NOTE: at this point you should read the file README included in the directory pc400-<version>to learn about any changes implemented since this manual was produced.

(to run the install script)

This script will detect the system information (kernel version, current Cyclades-PC400 driver version, etc.) and install the proper driver package files. A default configuration file will be placed in /etc/cyclades/pc400/ pc400.cfg and is used when /usr/local/sbin/pc400util -p is executed.The following utilities are compiled and installed :

/usr/local/sbin/pc400util

/usr/local/sbin/pc400load

/usr/local/sbin/pc400dump

/usr/local/sbin/pc400hwtest

/usr/local/sbin/pc400syslog

And the firmware is installed in /usr/local/lib/pc400.bin

If an older version of the PC400 driver already exists, the files pc400.c and pc400.h are backed up with modified names in the same directory. If a newer version is already installed, the files will not be updated with those of the older driver.

Configure the kernel by executing “make config” or “ make menuconfig”:

Please note the following before beginning the kernel configuration. The only difference between selecting ‘Y’ , ∗‘’ or ‘M’ is the following: ‘Y’ or∗’‘causes the driver to be compiled as part of the kernel and is activated every time the computer is booted; ‘M’ creates the driver as a module, which can be loaded or unloaded with a command without the need to reboot the computer.

Chapter 3 Software Installation

10

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Cyclades-PC400 FCC Warning Statement Cyclades-PC400 Installation ManualCanadian DOC Notice Table of Contents Appendix B Hardware Specifications What is in the BOX Upgrades of Software and ManualsStep One Hardware InstallationStep Two Step Three Step Four Step FiveSoftware Installation Software Installation Make config Make menuconfig Step ONE Board and System ConfigurationStep TWO Dspprofilebegin InterfnNbegin Label Description ISDN-PRI Profile Parameters Interface Parameters USA AT&T Pc400util -p Last or channelnumberchannelnumberchannelnumber etcPc400load Step ThreeStep Four Step Five Guided Examples for the Most Common ApplicationsLAN ISDN-BRIParameter Description Value for T1 Value for E1 Line RAS DIAL-IN Application Parameters∙∙∙ LAN Example 2 a LAN-to-LAN Example Using ChannelsETH0 10 Multiple LAN-TO-LAN Application Parameters ∙∙∙ Troubleshooting General TipsHardware Test Root@cyclades common# ./pc400hwtestPasses Pg0 Board ESC Previous Menu G Global E ErrorsGlobal Test DSP U19 U06 U20 U07Previous Menu G Global E Errors ESCAdministrative Utilities Passwd Users and PasswordsAppendix a Information for Users not Familiar with Linux Linux File StructureBasic File Manipulation Commands Cp filename destinationVi Editor Mode What is done there How to Get ThereVi filename Routing Table Netmask Netstat -rnNet-host Ssh The Secure Shell SessionLoading the Configuration File PID TTY Stat Time CommandProcess Table Syslog Minute hour date month day-of-week user commandGet information from the board Crond UtilityActive root /etc/tstcron.src Dhcp Dynamic Host Configuration Protocol Client59 * * * * /etc/testcron.sh Packet Filtering using ipchains Accept Deny Interface isCyclades-PC400 Installation Manual Appendix B Hardware Specifications RJ-48C Signal Pin RxTip RxRing TxTip TxRingCyclades Philippines
Top Page Image Contents