Label | Description |
onhook_timer | Valid only for CAS in Brazil. Valid values are |
| When the PC400 answers an incoming call it waits for the period defined by |
| answer2_timer, then it hangs up. Next, it waits the period defined by onhook_timer and |
| reconnects. The line remains active if the call was not a collect call. This is necessary |
| because in Brazil a collect call is accepted by simply remaining on the line. |
answer2_timer | Valid only for CAS in Brazil. Specifies the time that should elapse before answering an |
| incoming call. Valid values are |
| description of onhook_timer. |
trunk_number | Principal phone number assigned to the ISDN trunk line. Use the value none for this |
| parameter if the incoming number should not be confirmed by the PC400. This is |
| recommended when the provider does not send the trunk line number in the incoming |
| call message. The value should not exceed 30 characters. |
switch_type | Switch type when PRI signaling is used. au1 (for Australia), ets (for Europe ETSI), vn6 |
| (for France), tr6 (for Germany), dms (for USA – NorTel |
| Custom), ntt (for Japan), n_isdn2 (for USA – |
| USA – AT&T). |
idle_timeout | For PRI signaling mode, specifies the idle timeout, in minutes, to drop one call. The |
| value should not exceed 127 and 0 indicates no timeout. |
t200 | For PRI signaling mode, specifies the ISDN T200 parameter, which may not exceed 255. |
n200 | For PRI signaling mode, specifies the ISDN N200 parameter, which may not exceed 255. |
t203 | For PRI signaling mode, specifies the ISDN T203 parameter, which may not exceed 255. |
interf#_end | Marks the end of the configuration parameters for the first interface. See comments for |
| interf#_begin above. |
| FIG. 4.4 INTERFACE PARAMETERS (CONT.) |
Chapter 4 Board and System Configuration | 18 |