Cyclades PC400 installation manual Software Installation

Page 9

cd pc400-<version>

CHAPTER 3 SOFTWARE INSTALLATION

The PC400 driver diskette contains the files needed to run the Cyclades-PC400 in a Linux environment. This driver should run without problems with all processors supported by Linux. However, Ix86-compatible architectures are the only platforms officially supported by Cyclades.

This Installation manual assumes a minimum knowledge of the Linux operating system. Please read the file /usr/src/linux/README before continuing, in order to understand the basics of kernel compilation.

System Requirements for compatibility with the PC400:

•Linux kernel 2.2.17 or later or 2.4.0 or later.

•486 processor or better.

•PCI bus support.

These instructions assume that your kernel source tree is /usr/src/linux.

Before installing the driver, please back up any critical information in your system.

Log in to the Linux computer as root. Place the diskette in the diskette drive.

Execute the following commands, beginning from any directory:

cd /tmp

tar xvf /dev/fd0 (this command copies the tar file from the diskette to the directory /tmp) ls (to see the name of the tar file)

tar zxvf filename.tgz (to unzip and untar the file) ls (to see the name of the directory)

(to go to the newly created directory)

Chapter 3 Software Installation

9

Image 9

Contents Cyclades-PC400 Cyclades-PC400 Installation Manual FCC Warning StatementCanadian DOC Notice Table of Contents Appendix B Hardware Specifications Upgrades of Software and Manuals What is in the BOXHardware Installation Step OneStep Two Step Three Step Five Step FourSoftware Installation Software Installation Make config Make menuconfig Board and System Configuration Step ONEStep TWO Dspprofilebegin InterfnNbegin Label Description ISDN-PRI Profile Parameters Interface Parameters USA AT&T Pc400load Last or channelnumberchannelnumberchannelnumber etcPc400util -p Step ThreeStep Four Guided Examples for the Most Common Applications Step FiveISDN-BRI LANRAS DIAL-IN Application Parameters Parameter Description Value for T1 Value for E1 Line∙∙∙ Example 2 a LAN-to-LAN Example Using Channels LANETH0 10 Multiple LAN-TO-LAN Application Parameters ∙∙∙ General Tips TroubleshootingRoot@cyclades common# ./pc400hwtest Hardware TestGlobal Test ESC Previous Menu G Global E ErrorsPasses Pg0 Board DSP U19 U06 U20 U07ESC Previous Menu G Global E ErrorsAdministrative Utilities Appendix a Information for Users not Familiar with Linux Users and PasswordsPasswd Linux File StructureCp filename destination Basic File Manipulation CommandsMode What is done there How to Get There Vi EditorVi filename Routing Table Net-host Netstat -rnNetmask Ssh The Secure Shell SessionPID TTY Stat Time Command Loading the Configuration FileProcess Table Get information from the board Minute hour date month day-of-week user commandSyslog Crond UtilityDhcp Dynamic Host Configuration Protocol Client Active root /etc/tstcron.src59 * * * * /etc/testcron.sh Packet Filtering using ipchains Interface is Accept DenyCyclades-PC400 Installation Manual RJ-48C Signal Pin RxTip RxRing TxTip TxRing Appendix B Hardware SpecificationsCyclades Philippines