Telular SX7T, SX7M manual Connect the SX7 to Your Computer With a USB Cable

Page 15

USB Connection Option

Connect the SX7 to Your Computer With a USB Cable

1.With your computer and the SX7 powered on, connect the terminal end of the USB cable to the USB Type B Port on the SX7.

USB

(Type B)

Note

The USBhost (Type A) port on the SX7 is notcurrentlyactive.It is reservedforfuture use

2.Connect the other end of the USB cable to an available powered USB Type A port on your computer.

3.A Found New Hardware Wizard will open. Select “Install the software automatically (Recommended)” and click Next.

If a Windows Logo testing warning appears, click Continue Anyway.

4.Click Finish to complete the installation.

Set Up a Dial-Up Networking (DUN) Connection

1.With the drivers and USB modem installed and connected, click Start > Control Panel > Network Connections.

2.Click File > New Connections.... (The New Connection Wizard will start.)

3.Select the following settings and click Next after each selection:

Connect to the Internet.

Set up my connection manually.

Connect using a dial-up modem.

Set up my connection manually.

Wi PATHTM SX7

13

User Guide

Image 15

Contents Wi Pathtm SX7T Terminal and SX7M Modem User Guide Table of Contents USB Cable a to B not pictured RJ-11 Phone Cable IntroductionGetting Started With the Wi Pathtm SX7 YourWi PATHSX7 ComponentsTip Set Up Your SX7To power outlet Ground Connector Screw Connect the SX7 to Your Computer Power Up the SX7Connect to the Telular Device Manager Using the Telular Device ManagerTelular Device Manager Overview Setting Up YourWireless WAN Data Connection For PSD Auto Connect, click Always On Data ConnectionThe Basics LED Reference Table Status LEDsInstall the USB Drivers Using the USB Connection OptionConnect the SX7 to Your Computer With a USB Cable Set Up a Dial-Up Networking DUN ConnectionUSB Connection Option USB Connection Option Using the Voice Calling Features on Your SX7T Using the Voice and Fax Options SX7T OnlyFor MT Call Type 3 select FAX Next Call or FAX Always Using the Fax Function on Your SX7TPhone/Fax Voice/Fax Programming Pstn SettingsBasic Pots Setup Advanced Data Connection Options Setup OptionsSetup LAN LAN FeaturesDhcp Settings Setup Wireless WANSetup Keep Alive Setup Ddns Setup SIM Network Options Network RoutingRouter NAT off RIP Version Select v1 or v2 default Network Firewall/Filters Network DMZ Network Port ForwardingAdmin Management Administration OptionsAdmin Firmware Upgrade Admin Factory DefaultsStatus Router Status OptionsStatus LAN Ethernet Status Status LAN USB Status Wireless WAN Status Pstn Basic Pstn Call Control Pstn OptionsPstn Pots Setup Advanced Settings Configuring TCP/IP SettingsWindows XP Line Ring GlossarySX7 Connections An Overview WiPATH SX7 Rear Panel View and Connectors