Telular SX7T, SX7M manual Network Firewall/Filters

Page 31

Advanced Data Connection Options

Network > Firewall/Filters

The Firewall/Filters settings allow you to customize the following access settings for the SX7 on your network.

￿Firewall (SPI): Select Enable to use the SPI (Stateful Packet Inspection) firewall to monitor network connections and reject any that do not match its criteria.

￿LAN Port Filter Range: Select an option (see below) and a range (from 0 to 65535) of ports through which to allow connections.

●Disable: Do not apply a LAN port filter range.

●Both: Use both TCP and UDP port numbers for filtering.

●TCP: Use only TCP (Transmission Control Protocol) port numbers for filtering.

●UDP: Use only UDP (User Datagram Protocol) port numbers for filtering.

￿LAN IP Filter: Select Enable and either Only Allow IP Addresses on the List or Only Deny IP Addresses on the List to allow or deny connections with specific IP addresses. Click Edit IP Filter List to enter the IP addresses to allow or deny (up to 50).

￿LAN MAC Filter: Select Enable and either Only Allow MAC Addresses on the List or Only Deny MAC Addresses on the List to allow or deny connections with specific MAC addresses.Click Edit MAC Filter List to enter the MAC addresses to allow or deny (up to 50).

￿IPSec Pass Through: Select Enable to allow connections to pass through IP Security.

￿PPTP Pass Through: Select Enable to allow connections to pass through Point-to-Point Tunneling Protocol.

Wi PATHTM SX7

29

User Guide

Page 30 Page 32
Image 31
Page 30 Page 32
Contents Wi Pathtm SX7T Terminal and SX7M Modem User Guide Table of Contents USB Cable a to B not pictured RJ-11 Phone Cable IntroductionGetting Started With the Wi Pathtm SX7 YourWi PATHSX7 ComponentsTip Set Up Your SX7To power outlet Ground Connector Screw Connect the SX7 to Your Computer Power Up the SX7Connect to the Telular Device Manager Using the Telular Device ManagerTelular Device Manager Overview Setting Up YourWireless WAN Data Connection For PSD Auto Connect, click Always On Data ConnectionThe Basics LED Reference Table Status LEDsInstall the USB Drivers Using the USB Connection OptionConnect the SX7 to Your Computer With a USB Cable Set Up a Dial-Up Networking DUN ConnectionUSB Connection Option USB Connection Option Using the Voice Calling Features on Your SX7T Using the Voice and Fax Options SX7T OnlyFor MT Call Type 3 select FAX Next Call or FAX Always Using the Fax Function on Your SX7TPhone/Fax Voice/Fax Programming Pstn SettingsBasic Pots Setup Advanced Data Connection Options Setup OptionsSetup LAN LAN FeaturesDhcp Settings Setup Wireless WANSetup Keep Alive Setup Ddns Setup SIM Network Routing Network OptionsRouter NAT off RIP Version Select v1 or v2 default Network Firewall/Filters Network DMZ Network Port ForwardingAdmin Management Administration OptionsAdmin Firmware Upgrade Admin Factory DefaultsStatus Router Status OptionsStatus LAN Ethernet Status Status LAN USB Status Wireless WAN Status Pstn Basic Pstn Call Control Pstn OptionsPstn Pots Setup Configuring TCP/IP Settings Advanced SettingsWindows XP Line Ring GlossarySX7 Connections An Overview WiPATH SX7 Rear Panel View and Connectors
Top Page Image Contents