Telular SX7M, SX7T manual Advanced Settings, Configuring TCP/IP Settings, Windows XP

Page 40

Advanced Settings

Advanced Settings

This section explains some of the advanced configuration settings that may be required in some instances to make the SX7 operational on your computer.

Configuring TCP/IP Settings

If your computer is set up with a preset IP address (as may be the case with certain DSL and cable subscribers), you will need to configure your TCP/IP settings to automatically retrieve an IP address from the SX7 (see “Power Up the SX7” on page 5).

Windows XP

1.In the Windows taskbar, click Start > Control Panel.

2.Classic View: Double-clickNetwork Connections.

Category View: Click Network and Internet Connections > Network Connections.

3.Double-click the network interface card icon (usually labeled Local Area Connection) and then click Properties.

4.Highlight Internet Protocol (TCP/IP), make sure the box next to it is selected, and then click Properties.

5.Select Obtain an IP address automatically and Obtain DNS server address automatically, click OK, and then click OK again to save your settings.

Wi PATHTM SX7

38

User Guide

Image 40

Contents Wi Pathtm SX7T Terminal and SX7M Modem User Guide Table of Contents Introduction Getting Started With the Wi Pathtm SX7YourWi PATHSX7 Components USB Cable a to B not pictured RJ-11 Phone CableSet Up Your SX7 TipTo power outlet Ground Connector Screw Power Up the SX7 Connect the SX7 to Your ComputerUsing the Telular Device Manager Connect to the Telular Device ManagerTelular Device Manager Overview Setting Up YourWireless WAN Data Connection For PSD Auto Connect, click Always On Data ConnectionThe Basics Status LEDs LED Reference TableUsing the USB Connection Option Install the USB DriversSet Up a Dial-Up Networking DUN Connection Connect the SX7 to Your Computer With a USB CableUSB Connection Option USB Connection Option Using the Voice and Fax Options SX7T Only Using the Voice Calling Features on Your SX7TUsing the Fax Function on Your SX7T For MT Call Type 3 select FAX Next Call or FAX AlwaysPhone/Fax Pstn Settings Voice/Fax ProgrammingBasic Pots Setup Setup Options Setup LANLAN Features Advanced Data Connection OptionsSetup Wireless WAN Dhcp SettingsSetup Keep Alive Setup Ddns Setup SIM Network Routing Network OptionsRouter NAT off RIP Version Select v1 or v2 default Network Firewall/Filters Network Port Forwarding Network DMZAdministration Options Admin ManagementAdmin Factory Defaults Admin Firmware UpgradeStatus Options Status RouterStatus LAN Ethernet Status Status LAN USB Status Wireless WAN Status Pstn Options Pstn Basic Pstn Call ControlPstn Pots Setup Configuring TCP/IP Settings Advanced SettingsWindows XP Glossary Line RingWiPATH SX7 Rear Panel View and Connectors SX7 Connections An Overview