RAD Data comm ASMi-31 Appendix F Installation in 19 Rack, General Installation of a Single Unit

Appendix F

Installation in 19" Rack

General

Warning

Installation of a Single Unit

F.1 Installation of the ASMi-31 Unit in 19" Rack

The height of the unit is 1U (1.75"); the width of the unit is slightly less than half the available mounting width. A rack adapter kit, RM-9,is available for installing either a single unit or two units side by side in the 19" rack.

Disconnect the power before performing the procedures below. Installation, operation, and maintenance of this unit should only be performed by an experienced technician.

Rack adapter components for installing a single unit include one short bracket and one long bracket.

➤To install a single unit:

1.Fasten each bracket to the side walls of the unit by two screws which are inserted into the two front holes on the side wall. (The unit is supplied with nuts already in place on the inner side wall). Note that the short bracket fastens to the left side of the unit, and the long bracket to the right side of the unit (see Figure F-1).

Once the brackets are fastened to the side walls, the unit is ready for installation in the 19" rack.

2.Place the unit in the rack and fasten the brackets to the side rails of the rack using two screws on each side (not included in the kit).

Installation of the ASMi-31 Unit in 19" Rack F-1

Order from: Cutter Networks Ph:727-398-5252/Fax:727-397-9610 www.bestdatasource.com