Sony HMD-A240 manual Precautions, Table of Contents

Page 3

Table of Contents

 

Precautions

3

Setup

4

Adjustments

4

Technical Features

6

Troubleshooting

6

Specifications

8

Appendix

i

Preset mode timing table

i

Trinitronâand FD Trinitronâ are registered trademarks of Sony Corporation.

Macintosh is a trademark licensed to Apple Computer, Inc., registered in the U.S.A. and other countries.

Windowsâ and MS-DOS are registered trademarks of Microsoft Corporation in the United States and other countries.

IBM PC/AT and VGA are registered trademarks of IBM Corporation of the U.S.A.

VESA and DDCä are trademarks of the Video Electronics Standard Association.

ENERGY STAR is a U.S. registered mark.

All other product names mentioned herein may be the trademarks or registered trademarks of their respective companies.

Furthermore, “ä” and “â” are not mentioned in each case in this manual.

Precautions

Warning on power connections

Use the supplied power cord.

Before disconnecting the power cord, wait at least 30 seconds after turning off the power to allow the static electricity on the screen’s surface to discharge.

After the power is turned on, the screen is demagnetized (degaussed) for about 5 seconds. This generates a strong magnetic field around the screen which may affect data stored on magnetic tapes and disks placed near the monitor. Be sure to keep magnetic recording equipment, tapes, and disks away from the monitor.

The equipment should be installed near an easily accessible outlet.

Installation

Do not install the monitor in the following places:

on surfaces (rugs, blankets, etc.) or near materials (curtains, draperies, etc.) that may block the ventilation holes

near heat sources such as radiators or air ducts, or in a place subject to direct sunlight

in a place subject to severe temperature changes

in a place subject to mechanical vibration or shock

on an unstable surface

near equipment which generates magnetism, such as a transformer or high voltage power lines

near or on an electrically charged metal surface

in a dusty or smoky environment

inside an enclosed rack

Protection

Do not put foreign objects into the monitor.

Disconnect the monitor if environment exceeds 60°C/140°F.

Ensure AC power cord is not trapped under furniture, TV, etc.

Do not overload wall outlets, extension cords, or convenience receptacles beyond their capacity.

Never spill liquid of any kind on the monitor.

Notes on cleaning the screen’s surface

The screen’s surface is covered with a thin anti-reflective coating to enhance the ergonomic characteristics of the monitor. To ensure that the coating is not damaged, use a soft cloth to clean the screen’s surface. If necessary, use a soft cloth lightly moistened with a mild detergent solution, such as hand soap, to wipe the screen.

Do not use any type of abrasive pad, alkaline cleanser, scouring powder, or solvents such as alcohol or benzene as they might damage the anti-reflective coating.

• If you use a glass cleaning liquid, do not use any type of cleaner

US

containing an anti-static solution or similar additive as this may

 

 

scratch the screen’s coating.

 

Do not rub, touch, or tap the surface of the screen with sharp or abrasive items such as a ballpoint pen or screwdriver. This type of contact may result in a scratched picture tube.

Notes on cleaning the cabinet

Clean the cabinet, panel and controls with a soft cloth lightly moistened with a mild detergent solution.

Do not use any type of abrasive pad, scouring powder or solvent, such as alcohol or benzene.

Transportation

When you transport this monitor for repair or shipment, use the original carton and packing materials.

Display Stand

Do not remove this monitor’s stand.

Use of the tilt-swivel

This monitor can be adjusted within the angle shown below. To turn the monitor vertically, hold it at the bottom with both hands. Be careful not to pinch your fingers at the back of the monitor when you tilt the monitor up verticaly.

90°

15°

90°

Centering line

3

Image 3
Contents Trinitronâ Color Computer Display SONY7669 Declaration of ConformityTable of Contents PrecautionsConnecting to a Macintosh or compatible computer SetupAdjustments Adjusting the brightness and contrastOn-Screen menu adjustments To adjust the color of the pictureTo reset the adjustment Power saving function Technical FeaturesTroubleshooting Preset and user modesIf OUT of Scan Range appears If no Input Signal appearsIf Monitor is in Power Save Mode appears On-screen messagesSelf-diagnosis function SpecificationsDamper wires If thin lines appear on the screenPrécautions Réglage de la luminosité et du contraste ConfigurationRéglages Navigation dans le menuRéglages du menu d’écran Pour régler la couleur de l’imageRéinitialisation des réglages Fonction d’économie d’énergie Caractéristiques techniquesDépannage Modes préréglés et personnalisés1Si PAS Entree Video s’affiche 1Si Moniteur EN Mode D’ECONOMIE ’ENERGIE s’afficheMessages à l’écran Si Hors Plage DE Balayage s’afficheFonction d’auto-diagnostic SpécificationsSi des lignes fines apparaissent à Precauciones Ajuste del brillo y el contraste ConfiguraciónAjustes Navegación por el menúRestauración de los ajustes Para reconfigurar el ajuste para la señal de entrada ActualAjustes de menús en pantalla Para ajustar el color de la imagenFunción de ahorro de energía Solución de problemasCaracterísticas técnicas Modos predefinidos y de usuarioSi aparece Monitor EN Modo Ahorro Energia Mensajes en pantallaSi aparece Fuera DEL Rango DE Ajuste Si aparece SIN Señal DE EntradaHilos de amortiguación EspecificacionesSi aparecen líneas finas en pantalla Función de autodiagnósticoPreset mode timing table For HMD-A240 Preset mode timing table For HMD-A440Appendix Page Page HMD A230