Sony RX100 manual Rx+, # Autopan, DAY Night Mode, ‘#’ Lights

BBV Rx100 Interface Receiver

Addendum to manual for the following domes:

Borsatec BT2790FF Dome

Rx100 software RX1_B3V2

Application Notes

The RX100 provides the following functionality when controlling the above mentioned dome:

Variable speed Pan/Tilt.

16 Full scene presets.

2 RX100 preset patrols. Pattern 1 learn and playback 2 preset patrols.

4 alarm inputs moving to preset 1 - 4

Additional commands:

AUTOPAN calls scan - goto preset 66

LIGHTS operates the dome AUX 1 relay - goto preset 94

WIPER Disabled

WASH Disabled

RS485 control of dome using the following connections:

Notes:

The alarm output relay opens for approx 5 seconds upon power up. This can be used to signal power loss, etc.

Set the Dome address to 1, SW1 1 ON, 2-8 OFF

Protocol - Protocol and Baud, SW2 1-7 OFF, 8 ON, Pelco D - 2400 Baud

Shorting the TEST link after power up will pan the dome LEFT and ZOOM IN. Releasing the short will stop pan and zoom out. This is allows confirmation of correct wiring and switch settings at the dome.

Link J6/3-4 – Dome enters preset patrol after 5minutes of inactivity. Link J6/4-5 disabled.