BBV Rx 100 Interface Receiver
Addendum to manual for the following camera:
Sony
Rx100 software RXS4V3
Coaxial telemetry ONLY. Not twisted pair.
Application Notes
Variable speed Pan/Tilt.
Zoom/Focus, Autofocus with manual override (returns to auto following zoom command) 6 full scene presets
2 preset patrols
4 alarm inputs driving to preset 1 – 4
Advanced Features | Tx400 | Tx1000 | Tx1500 DM Sprite/DS2/BX2 | |
Toggle Backlight compensation | '#' ‘1’ | ‘#’ WASH | 1 ‘#’ | *889 002 or 10 10 2 |
Cycle White Balance | ‘#’ ‘2’ | ‘#’ WIPE | 2 ‘#’ | *889 003 or 10 10 3 |
AUTO, INDOOR, OUTDOOR |
|
|
|
|
Toggle AutoExposure/Bright mode | ‘#’ ‘3’ | ‘#’ AUTOPAN | 3 ‘#’ | *889 004 or 10 10 4 |
Iris keys used in Bright mode |
|
|
|
|
Reset dome to default | ‘#’ ‘4’ | ‘#’ LIGHTS | 4 ‘#’ | *889 005 or 10 10 5 |
RS232 control of dome 9600 Baud, No parity, 8 data bits, 1 stop bit. The camera uses a
Connection details:
Camera Pin | Description | Rx100 |
|
5 | Receive Data | J3/C1 | |
4 or 6 | Ground | J3/GND |
Notes:
Link
The alarm output relay opens for approx 5 seconds upon power up. This can be used to signal power loss, etc.
Check with the multiplexer manual for exact procedure for entering * commands.
IMPORTANT:
Ensure that CAMERA NO switch on the camera rear panel is set to 1.
As communications is RS232 please limit cable from Rx100 to camera to less than 5M.
Rx100 installation manual V1.17 29 Aug 08.doc | Page 30 |