National Instruments WAP-3711 NI WAP-3701/3711 User’s Manual Regulatory Statement, Safety

Page 45

NI WAP-3701/3711 User’s Manual

Regulatory Statement

Safety

This equipment is designed with the utmost care for the safety of those who install and use it. However, special attention must be paid to the dangers of electric shock and static electricity when working with electrical equipment. All guidelines of this and of the computer manufacture must therefore be allowed at all times to ensure the safe use of the equipment.

EU Countries Intended for Use

The ETSI version of this device is intended for home and office use in Austria, Belgium, Denmark, Finland, France (with Frequency channel restrictions), Germany, Greece, Ireland, Italy, Luxembourg, Portugal, Spain, Sweden, The Netherlands, and United Kingdom.

The ETSI version of this device is also authorized for use in EFTA member states Norway and Switzerland.

EU Countries Not Intended for Use

None.

Potential Restrictive Use

France: only channels 10, 11, 12, and 13.

C-2

Image 45

Contents First Edition, Sept NI WAP-3701/3711 User’s ManualCopyright Notice TrademarksDisclaimer Table of Contents Page Introduction Product Features Package ChecklistProduct Specifications OverviewPower Software FeaturesInterface MechanicalGetting Started ‰ Confirming the Settings of the AP and Client ComputersNI WAP-3701/3711 User’s Manual Getting Started First-Time Installation and ConfigurationAP Client AP/BridgeReview and Apply Settings Configure the NI WAP-3701/3711’s Ieee 802.11 settingsSetting up Client Computers Deploying the Access Point APConfiguring Ieee 802.11g-related Settings To establish a wireless link to an Access PointConfiguring TCP/IP-related Settings Confirming the Settings of the AP and Client ComputersChecking if the Ieee 802.11g-related Settings Work Checking if the TCP/IP-related Settings WorkNI WAP-3701/3711 User’s Manual Getting Started Web Console Configuration Menu Structure NI WAP-3701/3711 User’s Manual Web Console ConfigurationAssociated Wireless Clients Save, Save & Restart, and Cancel ButtonsViewing Status Home and Refresh ButtonsLink Monitor AP Client mode only Current Dhcp MappingsSystem Log General Operations Specifying the Operational ModeSTA-AP WDSAdministrative Password Managing the FirmwareUpgrading the Firmware by Http Upgrading Firmware by Tftp Backing up and Restoring Configuration Settings by HttpChoose Tftp as the Firmware management protocol Backing up and Restoring Configuration Settings by Tftp Configuring TCP/IP-related Settings Resetting the Configuration to Factory DefaultsAddressing Dhcp Server AP/Bridge modes only BasicStatic Dhcp Mappings Configuring Ieee 802.11g-related Settings CommunicationLink Integrity Wireless Distribution System Association ControlAP Load Balancing Sample wireless bridge network topology Network topology containing a loop SecuritySTA Shared Key , and Auto MAC-Address-Based Access Control Set the Access control type to exclusiveSet the Access control type to inclusive Click Download Ieee 802.1X/RADIUS AP mode onlyIeee 802.1X and Radius InternetPacket Filters Configuring Advanced SettingsEthernet Type Filters IP Protocol FiltersTCP/UDP Port Filters ManagementUPnP System LogSnmp Default Settings LAN Interface NI WAP-3701/3711 User’s Manual Default SettingsManagement Snmp read communityWireless Settings Problems TroubleshootingTCP/IP Settings Problems NI WAP-3701/3711 User’s Manual TroubleshootingAP does not respond to ping from the client computer Wireless Router/AP Browser Unknown ProblemsNI WAP-3701/3711 User’s Manual Troubleshooting Regulatory Statement Federal Communication Commission Interference StatementTTE Compliance Statement NI WAP-3701/3711 User’s Manual Regulatory Statement SafetyTechnical Support and Professional Services Worldwide Technical Support and Product Information National Instruments Corporate HeadquartersWorldwide Offices