Dell 6350 manual Ljxuh, Lvnhwwhulyh$Vvhpeo

'LVNHWWH￿'ULYH￿$VVHPEO\

diskette drive slot

interposer card

interposer cable

diskette drive bracket

)LJXUH￿￿￿￿	control panel
bracket latch
	diskette drive

To remove the diskette drive, follow these steps:

1.Remove the front bezel.

2.Remove the system fan assembly.

3.If necessary, open the top panels of the system unit.

4.Inside the chassis, detach the diskette drive interface and power cables from the interposer card at the back of the diskette drive bracket

(see Figure 4-6).

5.Using a Phillips-head screwdriver, detach the control panel from the front of the chassis and fold it to the right of the diskette drive slot.

6.Remove the screw at the front of the diskette-drive bracket, and pull the bracket/drive assembly out of the slot.

The replacement drive and bracket come preassembled. When installing the assembly in the diskette drive slot, position the flat side of the diskette drive bracket against the left wall of the diskette drive slot (make sure the control- panel ribbon cable is placed to the right of the drive assembly). Slide the assembly into the chassis with the bracket flat against the slot wall. When the assembly is about 2 inches into the chassis, the edges of the bracket should start engaging the slide tracks on the slot wall. If the bracket does not engage the tracks, remove the assembly and try again.

4-8 Dell PowerEdge 6350 Systems Service Manual