Dell 6350 manual Ljxuh, Xlgh%Udfnhw$Vvhpeo

*XLGH￿%UDFNHW￿$VVHPEO\

screws (2)

guide bracket

)LJXUH￿￿￿￿￿

To remove the guide bracket assembly, follow these steps:

1.Remove the system board.

2.Remove terminator card and SEC cartridge/heat sink assemblies if necessary.

3.From the underside of the system board, use a T25 Torx driver to remove the screws at each end of the bracket(s) (see Figure 4-22).

4.For each guide bracket, squeeze the bracket retaining tabs on the under- side of the system board to release the bracket, and pull the bracket away from the system board.

NOTE: Because of the way the guide brackets overlap each other, the guide

bracket assembly must be removed in the following order: PROC_4 (the bracket shown being removed in Figure 4-22), PROC_3, PROC_2, PROC_1. Reinstall them in reverse order.

Removing and Replacing Parts 4-27