auxiliary SCSI backplane
SCSI backplane
drive carrier handles
)LJXUH
5.Remove the horizontally mounted auxiliary SCSI backplane.
Remove the two screws securing the auxiliary SCSI backplane to the top of the drive cage, slide the board toward the front of the unit to disconnect it from the vertically mounted SCSI backplane, and lift it away from the chassis.
6.At the back of the drive cage, disconnect all cables from the vertically mounted SCSI backplane, noting where the cables connected.
7.Loosen the thumbscrew on the backplane, slide the backplane upward about a quarter inch, and lift it off the mounting hooks on the
NOTE: Whenever the auxiliary SCSI backplane has been disconnected from the SCSI backplane, after reassembling the system you will need to reflash the SCSI backplane firmware.
Removing and Replacing Parts |