Dell 6350 manual Figuration

7DEOH0HVVDJH￿￿￿￿6\VWHP&DXVH0HVVDJHVFRQWLQXHG&RUUHFWLYH$FWLRQ

Embedded	Embedded server	Shut down the system to
server	management	clear the memory, and
management	memory may be	then restart the system.
error	temporarily	If the problem persists,
	corrupted	disconnect the AC power
Embedded		cable for about 5 min-
server		utes and try again.
management
is not
present
Gate A20	Faulty keyboard	Replace the system
failure	controller (defective	board.
	system board)
General	Operating system	Reinstall the operating
failure	corrupted or not	system.
	installed properly
Hard disk	Incorrect SCSI con-	Check the primary and
drive read	figuration settings,	secondary SCSI
failure	improperly con-	configuration settings in
	nected hard-disk	the SCSI configuration
Hard disk	drive, faulty hard-	utility. Reinstall the hard-
failure	disk drive controller	disk drive. Check the
	subsystem, or loose	interface cable and
	power cable	power cable connections
		to the backplane board. If
		the problem still persists,
		replace the system
		board.
Invalid con-	Incorrect ISA_CLR	Remove the plug from
figuration	jumper configura-	the ISA_CLR jumper.
information -	tion, incorrect	Check the System Setup
please run	configuration set-	configuration settings.
SETUP program	tings in System	Replace the battery.
	Setup program, or
	faulty battery
Invalid CPU	Incorrect micropro-	Check the microproces-
speed	cessor jumper	sor speed jumper.
detected -	configuration
check
jumpers
Invalid	System detected	No action is required.
NVRAM con-	and corrected a
figuration,	resource conflict
resource	when system
reallocated	resources were
	allocated using the
	RCU

Codes and Messages 3-7