Dell 3000i manual Addresses on each controller, Initial Setup Tasks→ Configure, Array discovery

Table 4-5. Initial Storage Array Setup Tasks (continued)

Task	Purpose	Information Needed
Set the management port IP	To set the management port IP	In MD Storage Manager, select
addresses on each controller.	addresses to match your public	Initial Setup Tasks→ Configure
	network configuration. Although	Ethernet Management Ports, then
	DHCP is supported, static IP	specify the IP configuration for each
	addressing is recommended.	management port on the storage
		array controllers.
		NOTE: If you change a management
		port IP address, you may need to
		update your management station
		configuration and/or repeat storage
		array discovery.
Set up alert notifications.	To arrange to notify individuals (by	E-mail — Sender (sender’s SMTP
Set up e-mail alerts.	e-mail) and/or storage management	gateway and e-mail address) and
Set up SNMP alerts.	stations (by SNMP) when a storage	recipients (fully qualified e-mail
	array component degrades or fails,	addresses)
NOTE: The Status area in the	or an adverse environmental	SNMP — (1) A community name, a
	condition occurs.
		known set of storage management
Summary tab shows if alerts have
		stations set by administrator as an
been set for the selected array.
		ASCII string in the management
		console (default: "public"), and (2)
		a trap destination, IP address or host
		name of a management console
		running an SNMP service

38

Setting Up Your iSCSI Storage Array