discovery.sendtargets.auth.password = password_1
discovery.sendtargets.auth.username = iqn.1984- 05.com.dell:powervault.123456
discovery.sendtargets.auth.password_in = test1234567890
If you are using SLES10 SP1 via the GUI
1Select Desktop→ YaST→ iSCSI Initiator.
2Click Service Start, then select When Booting.
3Select Discovered Targets, then select Discovery.
4Enter the IP address of the port.
5Click Next.
6Select any target that is not logged in and click Log in.
7Choose one:
•If you are not using CHAP authentication, select No Authentication. Proceed to step 8.
or
•If you are using CHAP authentication, enter the CHAP username and password. To enable Mutual CHAP, select and enter the Mutual CHAP username and password.
8Repeat step 7 for each target until at least one connection is logged in for each controller.
9Go to Connected Targets.
10Verify that the targets are connected and show a status of true.
Setting Up Your iSCSI Storage Array
53