Advantech EKI-1351, EKI-1352 manual Diagnostic Infrastructure Mode, Without wireless module

Page 65

7.Reset the Ethernet Basic settings and Wireless Basic settings as needed. (About these settings, please refer to section 3.3.1 and 3.3.2 of the manual)

8.Power off EKI-1351/1352, adjust the switch to Normal Mode, and then reboot it to finish the wireless connection. Now you can configure and set up port mapping though the access point.

A.2 Diagnostic Infrastructure Mode

(Without wireless module)

1.Set the switch of EKI-1351/1352 to Normal Mode, then power on.

2.Wait for 10 to 20 seconds until the signal quality is stable.

3.Adjust the switch to Diagnostic Mode, and then wait for 5 seconds until the signal strength LED is blinking.

4.Return the switch to Normal Mode, then EKI-1351/1352 will reboot automati- cally with Diagnostic Infrastructure Mode. Now EKI-1351/1352 will automatically search the field site for access points and create a connection to the one with best signal strength.

5.Start the Serial Device Server Configuration Utility tool on your host PC (ensure your host PC and the possible access points that EKI-1351/1352 can connect to, are in the same network). Find the EKI-1351/1352 on the network.

6.Reset the Ethernet settings as required. (About these settings, please refer to section 3.3.1 of the manual)

7.Power off EKI-1351/352, confirm the switch on Normal Mode, and then reboot it to finish the wireless connection. Now you can configure and set up port map- ping through an access point.

Appendix A Quick Start

59	EKI-1351/1352 User Manual

Image 65

Contents EKI-1351/1352 Copyright Acknowledgements Product Warranty 2 yearsDeclaration of Conformity Safety InstructionsTechnical Support and Assistance FCC Class BSafety Precaution Static Electricity Contents Appendix a Setting COM RedirectorChapter Introduction Specifications FeaturesPackage Check List Getting Started Product Description Understanding EKI-1351/1352COM Port Redirector Virtual COM Port Normal ModeMulti-Access Mode Multi-Access Mode Shared COM port modeTCP Client Mode TCP Server ModeControl Mode Serial Tunneling ModeUDP Server/Client Mode Hardware LED IndicatorsEKI-1351 and EKI-1352 Dimensions Units mmBack View of EKI-1351/1352 Panel/Wall Mounting Connecting HardwareChoosing the Location 12 DIN-rail Step DIN Rail MountingPower Connection Wireless ConnectionSerial Connection Serial Device Server Configuration UtilityPage Getting Started Page Configuration Configuration Utility Overview Auto Searching Discovering Serial Device ServersPage Configuration Manual Appending Clear Device List and Search AgainEthernet Basic Setting Ethernet ParametersAssociation Information Wireless BasicsWireless Basic Information Wireless Basic Settings Site Survey Wireless Authentication Page Beacon Interval Wireless AdvancedRTS Threshold Setting Serial ParametersFragment Threshold Preamble TypeSetting Serial Port Parameters Setting Virtual COM Operating Mode Parameters Configuration Setting TCP/UDP Server/Client Operating Mode Parameters Configuration Setting Control Operating Mode Parameters AT Commands List Accessible Function Security ConfigurationPort Monitor Fulfilling Administrator FunctionsLocate Serial Device Import/Export Serial Port SettingLock Device Restore to Factory Default SettingsUpgrading the Firmware Configuration Page Setting COM Redirector Auto Mapping Setting COM RedirectorVirtual COM portSetting COM Redirector Manual Mapping Auto Reconnect Property Remove the Virtual COM Port Manual Direct Mapping Virtual COM PortRunning Diagnostic Test Page Appendix a With wireless module Diagnostic Ad hoc ModeWithout wireless module Diagnostic Infrastructure Mode