Packard Bell GX manual DVD Drive, Removing the DVD drive screw cover

Page 13

12

DVD Drive

To remove the DVD drive, first remove the battery (see Battery on page 4) and then perform the following steps:

1. Remove the rubber insert from the bottom of the notebook.

Fig. 20 Removing the DVD drive screw cover.

2. Remove the screw that secures the DVD drive to your notebook.

Fig. 21 Location of the DVD drive screw.

3. Carefully slide the drive out of the drive bay.

Fig. 22 Removing the DVD drive.

Packard Bell iPower GX Disassembly Manual

Image 13

Contents IPower GX Table of Contents Reassembly DisassemblyAbout This Guide For More Information Technician NotesHazardous Voltage Power Supply UnitAvoid Electrostatic Discharge Memory BatteryOpening the CPU bay cover CPU Heat SinkCPU Releasing the CPU screw Wireless LAN AdapterCarefully disconnect the two WiFi antenna cables Removing the wireless LAN adapter RTC BatteryLocation of the hard disk drive bay cover screws Hard Disk DriveSeparate the metal bracket and the hard disk drive Removing the DVD drive screw cover DVD DriveLocation of the keyboard cover screws Keyboard CoverVolume Control Board Power Button BoardMultimedia Board Location of the volume control boardReleasing the multimedia board KeyboardReleasing the keyboard flat cable LCD BezelWebcam InverterRemoving the webcam module LCD AssemblyLCD Panel Disconnecting the Wlan antenna cablesTop Cover LCD Panel HingesReleasing the touchpad flat cable Removing the top cover Touchpad BoardTouchpad Button Board Disconnecting the touchpad flat cableFingerprint Reader BluetoothModem Disconnecting the Bluetooth cableRemoving the modem Speaker AssemblyMain Board Location of the speaker assembly screwsRemove the modem cable from the main board retaining clips Location of the main board screws GPU Heat SinkLocation of the GPU heat sink screws Modem Jack / USB BoardExtracting the modem jack / USB board screw System FanIPower GX Disassembly Manual