5
2.Use the thumb notch to lift the CPU bay cover and remove it. Be careful not to break off the tabs located on the end of the cover opposite the thumb notch.
Fig. 4 Opening the CPU bay cover.
3.Gently press outward the clip on each side of the memory module; the module will eject upward.
Fig. 5 Releasing the installed memory module.
4. Carefully remove the memory module out of the slot.
Fig. 6 Removing the memory module.
CPU Heat Sink
To remove the CPU heat sink, first remove the battery (see Battery on page 4) and then perform the following steps:
1.Loosen the screws securing the CPU bay cover; the screws cannot be removed (see Fig. 3).
Packard Bell iPower GX Disassembly Manual