VTrak J610s, J310s Product Manual
Installing Disk Drives
Populate the VTrak with
Install all of the drive carriers into the J610s or J310s enclosure to ensure proper airflow, even if you do not populate all the carriers with disk drives.
Caution
Use only the
Figure 8. J610s and J310s unit drive carrier mounting holes
AAMUX | Disk Drive Mounting Holes |
Mounting Holes | with AAMUX |
WARNING:
Disk Drive Mounting Holes without AAMUX
1.Remove the front bezel (drive door).
2.Remove a disk drive carrier.
3.Optional. The AAMUX adapter is recommended for J610s and J310s enclosures with two I/O modules, so that both modules can access a SATA disk drive.
Place the optional AAMUX into the disk drive carrier and attach it with the four screws.
•Install only the screws supplied with the AAMUX.
•The AAMUX fits into the carrier with the SAS connector at the back. See Figure 6 on page 18
•Snug each screw. Be careful not to over tighten.
4.Carefully lay the drive into the drive carrier at the front, so that the screw
holes on the bottom line up.
16