Promise Technology J310S, J610S manual Route Command

	Chapter 3: Management
P15 ---------- ---------- ---------- ----------	---------- ---------- 0x01

P16 ---------- ---------- ---------- ---------- ---------- ---------- ----------

P17 ---------- ---------- ---------- ---------- ---------- ---------- ----------

P18 ---------- ---------- ---------- ---------- ---------- ---------- ----------

P19 ---------- ---------- ---------- ---------- ---------- ---------- ----------

InDW:Invalid Dword Count DsEr:Disparity Err Count

DwLo:Dword Sync Loss Count

PhRe:Phy Reset Problem Count CoVi:Code Violations Cnt

PRBS:PRBS Error Count

PhCh:Phy Change Count

The following items are reported in the table above. All counts are hexadecimal:

•Link number – Links are Phys, numbered P0 through P23

•Invalid D-word Count

•Disparity Error Count

•Phy Reset Problem Count

•Code Violation Count

•Pseudo-Random Bit-Stream Error Count

•Phy Change Count

If the count is zero, the counter shows dashes (----------). The fact that errors

occur does not necessarily indicate a problem or that the J610s or J310s unit is malfunctioning.

An individual error count incrementing at intervals of less than six minutes indicates a possible problem and requires further investigation.

To clear the link error count, at the cli> prompt, type link -a clear and press Enter.

Route Command

Use this command to show the SAS addresses of the devices in your domain.

At the cli> prompt, type route and press Enter.

Routing Table Mapping:
Entry# SAS Address	PortID CnID NextEntry NextValid

-------------------------------------------------------------------------------------

0083	500000E01122C533	0x10	CN1	----	0
0121	500000E01122C4A3	0x10	CN1	----	0
0226	500000E01122C513	0x10	CN1	----	0
0244	500000E011246263	0x10	CN1	----	0
0358	500000E011231F43	0x10	CN1	----	0
0466	500000E0112770B3	0x10	CN1	----	0

39