Pitney Bowes E589 manual Adjusting the Ejector Rollers

Page 22

Supplies and Adjustments

Adjusting the Ejector Rollers

If envelopes are not being ejected properly into the catcher tray, adjust the ejector rollers.

1. Loosen the knobs on the right side of the postage meter.

2. Adjust the knobs down until the steel rollers under the postage meter just touch the rubber rollers.

3. Tighten the knobs.

16

SV60975 Rev A

Image 22

Contents E589Series Mailing Machine Operating Guide FCC Compliance Mailing Machine Contents Contents Safety Precautions Page Introduction About Your Mailing MachineFeatures Feature FunctionTop Tension Knob Symbols Control PanelBefore You Run Envelopes or Print Tapes Before You Run Envelopes or Print Tapes To Print and Seal Envelopes EnvelopesTo print postage and seal the envelope To Print a Tape Page Locking the Mailing Machine to Prevent Use Adjustments and SuppliesLocking the Meter Removing the Postage Meter Refilling the Tape Dispenser Filling the Fluid Bottle Replacing the Ink Cartridge Adjusting the Ejector Rollers Adjusting the Feeder Ordering Supplies SupplyEnvelope/Tape Does Not Feed TroubleshootingMultiple Or Double Feeding Envelope Does Not Eject Envelope Does Not SealInsufficient Or Partial Sealing Envelopes Do Not Stay In Catcher TrayPostage Imprint Too Light Tape Does Not FeedPostage Imprint Incomplete Or Broken No Postage Imprint On Envelope Envelope Jams In Machine Print + SealTop Of Envelope Creased Specifications Environmental Compliance