Chapter 3 — Troubleshooting and Maintaining the SF51
Locating the SF51
If your SF51 is within Bluetooth communication range of your host PC, you can send the Bluetooth Device Page command from EasySet to locate the SF51.
Note: If the SF51 is turned off, your host PC cannot connect to it and send the Bluetooth Device Page command.
To page the SF51
1Start EasySet version 5.2 or later. Make sure that SF51 is selected as your product.
2Select Communication > Connect.
3Select the appropriate COM port, and click OK.
4Select the Send to product check box below the commands window.
5In the EasySet Commands window, select Configuration modes and utilities > Bluetooth device page.
The SF51 beeps continuously for 1 minute or until you find the SF51 and press the Scan button.
Resetting the SF51
If the SF51 appears to be locked up, you can reset it. When you reset the SF51, the scanner control firmware is restarted.
To reset the SF51
• Place the SF51 in the
If you have a Bluetooth connection, the SF51 disconnects from the host device.
28 | SF51 Cordless Scanner User’s Guide |