Chapter 4 — Configuration Command Reference
Timeout Between Identical Consecutive Codes
Use this command to invalidate a second bar code read that occurs before the timeout expires. Use this command when scanning bar codes with identical data as opposed to the Timeout Between Different Consecutive Codes command that you use when your bar codes contain different data.
You can set Timeout Between Identical Consecutive Codes to a value from 0 to 2550 ms.
Trigger Mode
Trigger mode allows you to set different types of triggering for the scanner.
Trigger Mode Options
Mode | Description |
Continuous/Edge | When you press the Scan button, the scanner |
| turns on and stays on. When you press the Scan |
| button a second time, the scanner turns off. |
| Simply releasing the button does not turn off the |
| scanner. |
|
|
Level | When you press the Scan button, the red scanner |
| beam turns on and stays on until you release the |
| Scan button or until the SF51 successfully |
| decodes a bar code. |
|
|
Pulse | Currently not supported. |
|
|
Flashing | Currently not supported. |
|
|
Autostand | Currently not supported. |
|
|
Aim | Aim triggering allows you to turn on the scanner |
| and aim the red scanner beam without causing a |
| decode. Releasing the Scan button enables the |
| decode. |
|
|
Note: EasySet contains a folder, predefined modes, in Operating settings > trigger activation. The commands in this folder are currently not supported on the SF51.
46 | SF51 Cordless Scanner User’s Guide |