Intermec PB3 manual Using the Battery and AC Adapter/Charger, To install the battery

Page 14

PB3 LED State Descriptions (continued)

LED	State	Description

Data and Status	Off	Card was read successfully, or card
		cannot be read (for optional magnetic
		stripe reader).

	Steady Green	Card reader is ready to accept data (for
		optional magnetic stripe reader).

	Flashing Red	Printhead is too hot. Printing is paused
		until printhead reaches normal
		operating temperature.

	Steady Red	One of three conditions:
		• Printer is out of paper.
		• The paper door is open.
		• Card reader error (for optional
		magnetic stripe reader).

Using the Battery and AC Adapter/Charger

Use Intermec battery model 318-040-001 only. Use of another battery may present a risk of fire or explosion.

The battery used in this device may present a fire or chemical burn hazard if mistreated. Do not disassemble, heat above 80°C (176°F), or incinerate.

Note: The battery must be cycled several times to achieve maximum capacity. To cycle a battery, fully charge it and then allow a full discharge through normal use. To ensure a full charge, do not operate the printer while charging the battery.

To install the battery

1Slide the battery door latch toward the belt loop knob to unlock the battery door, and open the battery door to an angle of about 90 degrees. Do not force the door all the way open.

2Orient the battery so the arrow points toward the battery contacts in the battery compartment.

4	PB3 Mobile Printer User’s Guide

Image 14

Contents PB3 PB3 Mobile Printer User’s Guide Document Change Record Version Number DatePB3 Mobile Printer User’s Guide Contents Pinout Diagram Before You Begin Safety InformationGlobal Services and Support Web Support Telephone Support To download documents Who Should Read This ManualRelated Documents Before You Begin Understanding the Printer Features Learning About the PB3 Mobile PrinterPB3 Feature Descriptions Feature DescriptionState Description Understanding the LEDsPB3 LED State Descriptions Using the Battery and AC Adapter/Charger To install the batteryTo remove the battery To charge the battery with the AC adapter/chargerUsing the 2-Bay Battery Charger To use the 2-bay chargerBattery Safety Information Loading Paper To load paperTearing Paper Using the Belt Loop Printing a Configuration Test To print a testCommunicating With a Host PBXA021ESetting Up Bluetooth or 802.11 Communications To download the Easy Configuration UtilitySetting Up IrDA Communications Setting Up Serial CommunicationsChanging Printer Connection Settings To change printer settings with the DIP switchesOFF DIP Switch Settings To Set This ParameterTo use the magnetic stripe reader Using the Magnetic Stripe ReaderMaintaining the Printer Troubleshooting To clean the printhead and platen rollerProblem Solution Problems and SolutionsPB3 Problems and Solutions Downloading Printer Software Software and Programming InformationCalling Product Support Installing Printer Firmware To install firmware and configure printer hardwareConfiguration Test Page on Select Control Macro Specification Description SpecificationsPB3 Mobile Printer Specifications Pin Signal Description AccessoriesPinout Diagram Serial Port Pin AssignmentsPage PB3 Mobile Printer User’s Guide