Intermec PB3 manual Battery Safety Information

Page 17

4Slide the battery towards the LEDs. The battery snaps into place.

If the battery is not charged, the Status LED for that bay turns red. The Status LED turns green when the battery is charged.

Battery Safety Information

Follow these tips for maintaining the PB3 battery:

•Be sure to fully charge the battery before long printing sessions, such as printing receipts with many bar codes and graphics.

•For maximum battery life, Intermec recommends charging the battery at 25°C (77°F).

•Remove the battery from the printer before storing the printer for long periods of time.

•The battery storage temperature is -20°C to 40°C (-4°F to 104°F). Do not store a fully charged battery at temperatures greater than 40°C (104°F) for long periods of time – the battery may permanently lose charge capacity.

•Dispose of battery according to local regulations. Do not throw in trash.

•Do not disassemble, short circuit, heat above 80°C (176°F), or incinerate. The battery may explode.

For more information, see the PB2 and PB3 Battery Instructions.

PB3 Mobile Printer User’s Guide

7

Image 17

Contents PB3 PB3 Mobile Printer User’s Guide Version Number Date Document Change RecordPB3 Mobile Printer User’s Guide Contents Pinout Diagram Before You Begin Safety InformationGlobal Services and Support Web Support Telephone Support To download documents Who Should Read This ManualRelated Documents Before You Begin Learning About the PB3 Mobile Printer Understanding the Printer FeaturesFeature Description PB3 Feature DescriptionsState Description Understanding the LEDsPB3 LED State Descriptions To install the battery Using the Battery and AC Adapter/ChargerTo charge the battery with the AC adapter/charger To remove the batteryTo use the 2-bay charger Using the 2-Bay Battery ChargerBattery Safety Information To load paper Loading PaperTearing Paper Using the Belt Loop To print a test Printing a Configuration TestPBXA021E Communicating With a HostTo download the Easy Configuration Utility Setting Up Bluetooth or 802.11 CommunicationsSetting Up Serial Communications Setting Up IrDA CommunicationsTo change printer settings with the DIP switches Changing Printer Connection SettingsOFF To Set This Parameter DIP Switch SettingsTo use the magnetic stripe reader Using the Magnetic Stripe ReaderMaintaining the Printer To clean the printhead and platen roller TroubleshootingProblem Solution Problems and SolutionsPB3 Problems and Solutions Downloading Printer Software Software and Programming InformationCalling Product Support To install firmware and configure printer hardware Installing Printer FirmwareConfiguration Test Page on Select Control Macro Specification Description SpecificationsPB3 Mobile Printer Specifications Pinout Diagram AccessoriesPin Signal Description Serial Port Pin AssignmentsPage PB3 Mobile Printer User’s Guide