HotBrick, Tel: 305 -398-0888, Fax: 305-398-5966
Quick installation - Primary setup
Connection mode
Enable Select this if you have connected a broadband modem to this port.
Disable – Select this if there is no broadband modem connected to this port.
Backup – Use this if you have a broadband modem on each port, and wish to normally use only one. Select Enable for the primary port, and Backup for the secondary port. The Backup port will
only be used if the primary port fails.
Connection type (Check the data supplied by your ISP, and select the appropriate option)
Static IP Select this if your ISP has provided a Fixed or Static IP address. Then enter the data into the Address Info fields.
Dynamic IP Select this if your ISP provides an IP address automatically when you connect. You can ignore the Address Info fields.
PPPoE – Select this if your ISP uses this method. (Usually, your ISP will provide some PPPoE software. This software is no longer required, and should not be used.) When this method is
selected, you must complete the PPPoE dialup fields.
Note: If using the PPTP connection method, select Static IP or Dynamic IP, as appropriate, according to the IP address method used by your ISP.
Address Info
This is for Static IP users only. Enter the address information provided by your ISP. If your ISP provided multiple IP addresses, you can use the
DNS
This is for Static IP users only. Enter the address information provided by your ISP. If your ISP provided multiple IP addresses, you can use the
Optional
Host name – This is required by some ISPs. If your ISP provided a Host Name, enter it here. Otherwise, you can use the default value.
Domain name – This is required by some ISPs. If your ISP provided a Domain Name, enter it here. Otherwise, you can use the default value.
MAC address – Some ISP's record your MAC address (also called "Physical address"
or "Network Adapter address"). If so, you can enter the MAC address required by your ISP in this field. Otherwise, this should be left at the default value.
19