HotBrick VPN 800/8 F manual Advanced configuration virtual server

HotBrick, Tel: 305-398-0888, Fax: 305-398-5966

Advanced configuration – virtual server

This screen allows you to define your own Server types:

Virtual Server Configuration

Enable – The enable checkbox enables or disables each Virtual server as required.

Server Name – Enter a name for this server. (By default, there are 12 well-known virtual servers on the Custom Virtual Server List that you may use.)

Protocol – Select the network protocol (TCP/UDP) used by this sever.

IP Address – LAN, Enter the IP address of the server on your LAN which is running the required Server software.

Each Host (server) should have a fixed IP address, or a reserved IP address. (See the Host IP section earlier in this Chapter for details on reserving an IP address.)

Each Host (server) must be running the appropriate Server software

WAN – This selection allows this server to bind to any selected WAN port, or to bind all WAN ports together.

LAN Port Range – Enter the range of port numbers used for outgoing traffic from this Server. If only a single port is required, enter it in both fields.

WAN Port Range -– Enter the range of port number used for incoming traffic to this Server. If only a single port is required, enter it in both fields

Allowed Remote IP – This allows only a range of remote side IP address to access the virtual servers. The default is 0.0.0.0 ~ 0.0.0.0, means all remote side IP address can access it.

Buttons

Add – Create a new Virtual Server entry.

Delete – Delete the selected entry.

31