HotBrick VPN 800/8 F manual Advanced configuration Routing, Dynamic routing, Static routing

HotBrick, Tel: 305 -398-0888, Fax: 305-398-5966

Advanced configuration – Routing

Routing

This section is only relevant if your LAN has other Routers or Gateways.

If you don't have other Routers or Gateways on your LAN, you can ignore the Static Routing page completely.

If your LAN has other Gateways and Routers, you must configure the Static Routing screen as described below. You also need to configure the other Routers.

Note:

If there is an entry or entries in the Routing table with an Index of zero (0), these are System entries. You cannot modify or delete these entries.

Dynamic routing

RIP v2 – This acts as a “master” switch. If enabled, the selected WAN or LAN will run RIPv1/v2. Otherwise theRIP function is not available.

Interface – LAN, WAN1 – n, is enabled, any WAN or LAN can execute the RIP function.

Static routing

Network Address – The network address of the remote LAN segment. For standard class "C" LANs, the network address is the first 3 fields of the Destination IP Address. The 4th (last) field can be left at 0.

Netmask –The Network Mask for the remote LAN segment. For class "C" networks, the default mask is 255.255.255.0

27