Chapter 3 — Operation
7Route the media through the slits in the front edge guides
8 Firmly close the top cover.
9If loading media for the first time or if changing from another type or size of media, perform a Label Gap Sensor Adjustment as described on page 28. Else, tap the Feed key either 4 times or until the indicator lamp glows green.
10 If the printer did run out of media while printing, the printing will automatically be resumed. Else, tear off excessive media by pulling it upwards against the tear bar.
Tear off the media upwards against the tear bar.
20 | EasyCoder PC4 User’s Guide |