Chapter 3 — Operation
6Similarly, install an empty core in the rewind (front) position.
7Route the end of the transfer ribbon forward under the printhead and up in front of it. Using the tape fitted at the front of the ribbon leader, affix the leader to the top of the rewind core. Be careful to
8Wind the green wheel on the right side of the rewind hub clockwise to wind up the leader onto the rewind core until the black
9If so required, also load a fresh supply of receiving face material, for example labels, according to instructions earlier in this chapter.
10 Close the print carriage by pressing it firmly down simultaneously on both sides. A loud click indicates locked position.
11 Firmly close the printer's top cover.
12 Tap the Feed key until the indicator lamp becomes green.
Removing a Partially Used Ribbon
When switching between direct thermal and thermal transfer printing, or when switching between different types of transfer ribbon, a partially used transfer ribbon can be removed and saved for later use.
1Open the printer's top cover by pressing the release buttons on both sides and folding the cover upwards/rearwards.
2Press the green release tabs at the bottom of the top cover on both sides of the printhead and fold down the print carriage halfway (45° angle) while keeping the top cover fully opened.
3Using a pair of scissors, cut the transfer ribbon just below the rewind roll.
4Rewind the unused ribbon onto the supply spool. Remove the roll by pushing it to the left until the right end disengages and then lifting the roll up. Fasten the loose end with a piece of tape or label to pre- vent the roll from unwrapping.
5Remove the rewind roll by pushing to the left and lifting up. Unwind the used ribbon into a waste basket or similar until you can dispose of it according to local environmental regulations. Keep the core! You will need it next time you load a ribbon.
EasyCoder PC4 User’s Guide | 27 |