Genicom PC4 manual Power Connection

Page 19

Chapter 2 — Installation

Power Connection

1Place the printer in a suitable location that allows easy access to printed labels and preferably also easy reload of media and transfer ribbon. The printer should only be operated while resting on a hori- zontal surface, like a table or similar.

The printer and power supply unit must never be operated in a location where they can get wet. Personal injury could result! Only use with power supply adapter Intermec SPN- 470-24 P/N 1-092515-XX.

2Place the power supply adapter in a suitable location between the printer and an electrical outlet, for example on the floor. The power supply adapter can be used for 100 to 240 VAC, 50 to 60 Hz. The configuration of the power cord plug differs according to national standards.

3Check that the printer’s On/Off switch at the back is off (O).

4First, fit the round connector into the power receptacle on the printer's rear plate. Then connect the power cord between the power supply adapter and an AC wall socket.

5The power can be switched on/off by means of the On/Off switch situated at the back of the printer. The indicator lamp on the printer lights green, red, or orange to indicate that the power is on. (It also indicates various conditions, see Chapter 3.)

Indicator lamp

Power receptacle

O

Power supply

Low voltage adapter cable

Power cord

I

On/Off switch

EasyCoder PC4 User’s Guide

7

Image 19
Contents EasyCoder PC4 Bar Code Label Printer 6001 36th Ave. W DOC Notice Canada FCC Notice United States of AmericaEU Standard EN 55022 The European Union Wichtige Sicherheitshinweise Safety Instructions EasyCoder PC4 Declaration of Conformity CEContents Interfaces TroubleshootingTechnical Data Media SpecificationsFirmware Upgrading Before You Begin Safety SummarySafety Icons Warranty Information Web Support Telephone Support Global Services and SupportIntroduction Description of EasyCoder PC4 Safety Summary Introduction Installation Unpacking Power Connection Memory Cartridge Installation of Memory CartridgeCentronics Parallel Interface Computer ConnectionUSB Interface Serial RS-232 InterfaceSoftware Installation Installation Operation On/Off Switch Controls and IndicatorsFeed Key Printer reset Indicator LampGreen solid Media loaded Media Compartment Tear-Off Media LoadLabel Taken Sensor Tear-Off Operation Operation Peel-Off Operation Operation Cut-Off Operation Operation External Supply Loading a Fresh Ribbon Roll Ribbon LoadRemoving a Partially Used Ribbon Label Gap Sensor AdjustmentTest Mode Operation Maintenance Printhead Cleaning External CleaningTroubleshooting Thermal Transfer Printing ProblemSolution or Reason Direct Thermal PrintingTechnical Data Ambient Temperature DimensionsNet Weight PowerPrinting Speed Printable AreaMedia Thermal Transfer RibbonsFormatting Bar CodesMemory User Interface Accessories and OptionsAppendix a Technical Data Media Specifications North America Direct Thermal MediaPremium Quality Economy QualityPolyethylene Plastics Thermal Transfer MediaUncoated Papers Coated PapersTransfer Ribbons Core Media Roll SizeRoll ← c → Label gap height Labels← a → Media width incl. liner ← b → Label length← c → Detection slot width Tags and Strip with Slots← a → Tag or strip width ← b → Tag length← c → Detection slot width ← c → Black mark width Tags and Strip with Black Marks← d → Black mark height Plain Continuous Stock Appendix B Media Specifications Interfaces Parallel Interface Pin Signal Name TransmitterDB-9 RS-232 Serial InterfaceUSB Interface Firmware Upgrading Using a Memory Cartridge Using a PCRequirements Instructions Appendix D Firmware Upgrading Page 960636-00