FujiFilm 3000 Troubleshooting, Error Messages and Responses, Error Message Description Response

Page 31

TROUBLESHOOTING

ERROR MESSAGES AND RESPONSES

If an error message appears on the display, follow the responses outlined below. If the printer fails to function properly even after corrective action has been taken, contact the dealer from whom you purchased your PosterPrinter 3000.

			Error Message	Description		Response
				The original has not been detected		Press the start/stop key to revert
				by the scanner within the		to the initial screen. Reset the
				by the scanner within the		to the initial screen. Reset the
				programmed time period.		original and press the start/stop
						key again.

				The original has jammed in the		Open the scanner cover and
				scanning unit.		remove the input document.
				scanning unit.		remove the input document.

				The scanner cover is open.		Firmly close the scanner cover.

				The printer cover is open.		Firmly close the printer cover.
				The printer cover is open.		Firmly close the printer cover.

				The paper has not been installed.		Install a paper roll.
				The paper has not been loaded		Reload the paper roll.
				correctly.

				The thermal heads have		Turn the power off, wait for at
				overheated.		least three minutes, and then turn
						the printer on again.

				When the power is turned on, or		Turn the power off, clean the
				after an error has occurred, the		shuttle shaft, and gently move the
				shuttle unit has not moved back		shuttle unit into home position
				into home position.		(on the right of the printer) with
						your hands. Turn the printer on
						again.

				There is some sort of failure with		Turn the power off and then on
				the printer.		again.

						If the printer fails to function
						properly even after corrective
						action has been taken, contact
						the dealer from whom you
						purchased your PosterPrinter
						3000. Be sure to tell your dealer
						which of the error messages was
						displayed.

9

29

Image 31

Contents USER’S Guide FCC IntroductionContents Unpacking the Printer Checklist of Items Included in PackageConnecting the Power Cord Installation SpaceDo not damage, crease or fold the power cord Safety PrecautionsGrounding Instructions for Proper USE of the Printer Variety of paper types and colors are available Main Features of the PosterprinterFront View Individual Part NamesRear View Printer ScannerFunction Control PanelOutput Size ModeContrast Paper remaining from the tip of the mark Installing PaperCorrect set position Setting the left paper bracketSetting the bracket in the printer Adjusting the left paper bracketBasic Functions Printing in Normal ModeWhat to do when a ‘document jam’ error occurs Points to note when using photo mode Printing in Photo ModePoints to note when using reverse mode Printing in Reverse ModeDivision Printing Using A123 paper to produce a 44x58 size posterPasting two output sheets together Printing Posters Smaller than the Paper Size Using A123 paper to produce a 20x27 size posterPoints to note in printing banners Printing Banners from Long Input DocumentsAdditional Functions Function ModeChecking Current Setting Setting FunctionsFunction mode Setting the Amount of Remaining Paper Remaining Paper ModePrinting the Amount of Remaining Paper Checking the Amount of Remaining PaperPrinting Area Scanning AreaThermal Transfer Paper TTP SuppliesDescription Direct Thermal Paper DTPThermal Transfer Paper TTP / Heavy Duty Poly Paper HDP Points Common to All Types of PosterPrinter SuppliesError Messages and Responses TroubleshootingError Message Description Response Problem Description and Remedies TroubleshootingDescription Remedy P29 Problem Part to Clean Cleaning the PrinterPlaten glass Power supply Scanning resolutionPrinting resolution Dimensions/weightIndex 26-30, Nishiazabu 2-chome, Minato-ku, Tokyo 106-8620, Japan