FujiFilm 3000 manual P29

	No.	Description	Remedy	Ref.
7		Tone of the images can not be	• Set the contrast level to lighter position to reduce the	P11
		reproduced in darker areas.	density.
			• If the images on the original are too dark, change to a
			better copy of the original where possible.
			• Check that the type of paper indicated on the message	P11
			display matches the type actually being used.
8		The printed poster does not appear.	• Open the cover of the printer and check to see if the paper	P12
			is caught in the paper feed rollers.
			• Check that the printer cover is closed properly.
9		The printer does not start to print even	• Place the original into the document bay until it stops.	P15
		after the start/stop key has been
			• The printer will not scan transparent documents. Make a
		pressed.	copy on plain paper and restart the process.
			• Check to see if an error message appears on the message	P29
			display.
10		Spots or marks appear in the margin area.	• Clean the thermal heads.	P32
			• Clean the platen glass in the scanner unit.	P33
11		A document jam occurs.	• Open the scanner cover and remove the original.	P15
			• Check that the scanner cover is closed properly.
			• If a document jam occurs again, check that the original has	P15
			been set properly.
12		The printing process is unexpectedly	• The printer automatically switches to a lower speed when	P17
		slow.	the thermal heads overheat. This typically occurs when
		(An “SLOW MODE” message will appear	printing posters with large black areas or when printing in
		on the display.)	reverse mode. This is normal, and does not indicate an
			error in the printing process.
13		A black band appears on the back of the	• A black band is printed on the direct thermal paper, to
		print.	indicate that the paper roll is nearly finished. Change the
			paper roll when the band appears.
	14	The printer makes a rattling or grating	• Clean the shuttle shaft.	P32
		noise, or the “SHUTTLE ERROR”	• Remove the packaging material in the shuttle shaft unit.	P2
		message appears on the display.
15		The ink sheet (thermal transfer paper,	• Check that the type of paper indicated on the message	P11
		HDP paper) has a lot of wrinkles in it.	display matches the type actually being used.		9
16		White bubbles appear on the printed	• Check that the type of paper indicated on the message	P11
		surface (thermal transfer paper, HDP	display matches the type actually being used.
		paper).
17		The poster is printed as a mirror image	• Change the setting in function mode ('IMAGE DIRECTION')	P22
		of the original.	to 'NORMAL'.
18		Low contrast on the message display.	• Remove the protective covering on the control panel.	P10

31