EPoX Computer KP6-FX2 manual I/O Shield Connector, Power-On/Off Remote

Page 11

Parallel Port

Introduction

1-5

1-3 I/O Shield Connector

The KP6-FX2 is equipped with an I/O back panel. Please use the appropriate I/ O shield. (refer to figure 1-3)

Figure 1-3: KP6-FX 2 I/O back panel Layout

PS/2 Mouse

PS/2 Keyboard

USB

COM1

COM2

1-3.1 Power-On/Off (Remote)

The KP6-FX2 has a single 20-PIN connector for ATX power supplies. For ATX power supplies that support the Remote On/Off feature, this should be connected to the systems front panel for system Power On/Off button. The systems power On/Off button should be a momentary button that is normally open.

The KP6-FX2 has been designed with “Soft Off" functions. You can turn Off the system from one of two sources: The first is the front panel Power On/Off button, and the other is the "Soft Off" function (coming from the KP6-FX 2’s on-board circuit controller) that can be controlled by the the operating system. Windows 95 will controll this when the user clicks is ready to Shutdown the system.

ATX

POWER SUPPLY

JP 16

KP6-FX 2 Board

Case (chassis) Power

ON/OFF button

Figure 3-3: Simple ATX Power ON/OFF Controller

11

Image 11

Contents 6 FX Modem Access Technical Support ServicesBios Upgrades Internet AccessUser Notice Handling ProceduresParts Checklist Table of Contents Appendixes Pentium II Processor CPU with C. Cartridge IntroductionPentium II Processor Overview 2 S.E.C. Cartridge Terminology 1 S.E.C. Cartridge OverviewKP6-FX 2 Specification KP6-FX 2 Form-Factor Overview Summary of ATX chassis featuresPower-On/Off Remote I/O Shield ConnectorSystem Block Diagram KP6-FX 2 Layout InstallationKP6-FX 2 Layout Power Saving LED indicator LED on when system is Connectors and JumpersCPU Clock Rate Select Essj JP5Connectors I/O Connectors Memory Configurations To enter Setup Program Award Bios SetupBios Features Setup Standard Cmos SetupBios Features Setup Award Bios Setup Typematic RateChars/Sec Choose the Chipset Features Setup in the Cmos Chipset Features SetupDram Read/Write Burst B/E/F The default value is x2/2/3 PCI Burst Write Combine CPU-To-PCI IDE Posting System Bios CacheableBit I/O Recovery Time The default value is CPU-To-PCI Write PostPower Management Setup Power Management SetupDescription of the Green Functions Power Down and Resume Events Standby ModeSuspend Mode HDD Standby ModePCI Configuration Setup PNP/PCI ConfigurationCombination of PCI INT# lines Integrated PeripheralsIDE Secondary Master PIO The default value is Auto Award Bios Setup Change Supervisor or User Password Load Setup DefaultsIDE HDD Auto Detection IDE HDD Auto DetectionLarge mode LBA Logical Block Addressing modeExit Without Saving Save & Exit SetupHDD LOW Level Format Address Range Size Description Appendix aMemory MAP MAPIRQ H/W Time & DMA Channels MAPInterrupt MAP RTC & Cmos RTC & Cmos RAM MAP01-02 Appendix BPost Codes POSThexProgram some of the Chipsets value according to Setup. Early Appendix Unexpected Errors Post hex Description Load Setup Default