Dell CPx H/CPx J Series, CPt V/CPt S Series manual Support.dell.com

Page 9

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿￿

This manual provides instructions for removing and replacing field-replaceable components, assemblies, and subassemblies in your Dell Latitude portable computer. Unless otherwise noted, each procedure in this manual assumes that a part can be replaced by performing the removal procedure in reverse order.

It is recommended that you use a book or something similar to support the display assembly when it is open nearly 180 degrees. The angle of the display assembly with respect to the bottom case should never be allowed to exceed 180 degrees. Also, when performing the procedures in this manual, the locations or directions relative to the computer are as shown in Figure 1 unless otherwise specified.

back of computer

left side

front of computer

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

right side

￿￿￿￿￿￿￿￿$￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿"￿

￿%￿￿￿￿￿￿￿￿￿%￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿$￿￿￿￿￿￿￿￿￿￿￿&

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

support.dell.com

Dell Latitude CPt V/CPt S Series and CPx H/CPx J Series Service Manual

1

Image 9
Contents Page Page Page Page Page Computer Orientation Vii Viii Support.dell.com +,&*-+ Battery bay latch Removable screws Movable part of connector Do not remove CUS, BTRY, 14.4V, 8CELL, Lith ASSY, CARR, HD SCR, M2X3, PHH, LP, ZPS DOOR, MEM, MET, NB Page Bottom of computer #$% Dimm a $6!%%!% Track stick Keyboard Scalloped edge of blank key Palmrest 22!%% Support.dell.com Page 789 Page +, -+!.+ % + % + Page #*+, -+!.+ =$% #=$ Back-light Support.dell.com Palmrest assembly consists of the touch pad and the palmrest Support.dell.com +.+ Support.dell.com Page Support.dell.com Mm screws M2.5x4 Thermal cooling assembly and exhaust fan Support.dell.com Bumps Wear ribs Index Page