Dell CPt V/CPt S Series, CPx H/CPx J Series manual

￿￿￿ ￿￿￿￿￿￿￿￿￿￿￿￿￿

display assembly

hinge cover

LCD flex cable snap tab

bottom case assembly

4-mm screws (3)

snap tab

M2.5x4

￿￿￿￿￿￿￿￿￿￿￿￿(￿%￿￿￿￿￿)%%￿￿!￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿ ￿￿￿￿￿"￿!￿￿￿￿￿￿"

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿"￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿$￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

1.Remove the main battery and secondary battery (if present).

2.Remove the keyboard.

3.Close the display and remove the three 4-mm screws, labeled with a “circle D,” from the back of the computer (see Figure 13).

4.Open the display and disconnect the LCD flex cable from the connector on the system board by pulling the connector straight up.

5.Lift the display assembly from the bottom case assembly. Pry the hinge cover loose at the seam from the snap tabs on the bottom assembly (see Figure 13).

NOTE: Always remove and replace the LCD panel as a complete assembly.

20 Dell Latitude CPt V/CPt S Series and CPx H/CPx J Series Service Manual