Dell MD3000 owner manual Installing the Control Panel

Figure 4-7. Removing and Replacing the Control Panel

2

1

3

1 faceplate screws (16) 2 control panel 3 thumbscrews

6Using a Torx T10 driver, remove all 16 screws from the front faceplate of the enclosure as shown in Figure 4-7.

7Remove the front faceplate from the enclosure and place it on a flat, secure surface.

8Slide the control panel assembly straight out from its connector on the backplane (see Figure 4-7).

Installing the Control Panel

1Align the top and bottom tabs on the control panel with the insert slots on the edge of the chassis (see Figure 4-7).

2Slide the control panel fully into the slot, making sure that its connector engages into the matching backplane connector (see Figure 4-7). Also, make sure the guide tab on the control panel is fully inserted into the mounting slot on the backplane.

3Replace the front faceplate and re-attach the 16 screws that hold it in place.

4Re-install any physical disks you removed (see "Removing and Installing Physical Disks" on page 56).

5Push the enclosure all the way back into the rack and tighten the thumbscrews.

Installing Enclosure Components

65